Revocation of NY N068156; Tariff Classification of a Square Metal Tubing Frame for a Mechanic’s Creeper from Mexico
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Key passages, quoted from the ruling
- Because the mechanic creeper 4 frame at issue in NY N068156 would ultimately become part of an upholstered mechanic creeper, the frame is classified in subheading 9401.71, HTSUS, which provides for other seats with metal frames that are upholstered.
Ruling text
This letter is to inform you that U.S. Customs and Border Protection (“CBP”) has reconsidered New York Ruling Letter (“NY”) N068156, issued to you on August 5, 2009, concerning the tariff classification under the Harmonized Tariff Schedule of the United States (“HTSUS”), of a square metal tubing frame for a mechanic’s creeper, under heading 8716, HTSUS. After reviewing this ruling in its entirety, CBP believes that the classification is erroneous. For the reasons set forth below, we hereby revoke NY N068156.
Pursuant to section 625(c)(1), Tariff Act of 1930 (19 U.S.C. § 1625(c)(1)), as amended by section 623 of Title VI (Customs Modernization) of the North American Free Trade Agreement Implementation Act, Pub. L. No. 103-182, 107 Stat. 2057, 2186 (1993), notice of the proposed action was published on May 27, 2026, in Volume 60, Number 10, of the Customs Bulletin. No comments were received in response to the publication.
FACTS: In NY N068156, CBP described the subject merchandise as follows: 1 The item under consideration is square metal tubing that is cut, drilled, bent and welded into the frame of a Mechanic’s Creeper which is used to roll underneath the chassis of a vehicle.
You state in your request that, in addition to the assembly described above, the frame will be cleaned, degreased, powder painted and have four (4) plastic plugs installed into pre-cut holes into which caster wheels will be mounted after importation into the U.S. along with any other additional components necessary to complete a finished Mechanic’s Creeper.
ISSUE: Whether the mechanic’s creeper frame is classified in heading 8716, HTSUS, which provides for “[t]railers and semi-trailers; other vehicles, not mechanically propelled; and parts thereof,” or heading 9401, HTSUS, which provides for “[s]eats (other than those of heading 9402), whether or not convertible into beds, and parts thereof.” LAW AND ANALYSIS: Merchandise imported into the United States is classified under the HTSUS.
Tariff classification is governed by the principles set forth in the General Rules of Interpretation (GRIs) and, in the absence of special language or context which requires otherwise, by the Additional U.S. Rules of Interpretation. The GRIs and the Additional U.S. Rules of Interpretation are part of the HTSUS and are to be considered statutory provisions of law for all purposes.
GRI 1 provides that the classification of goods shall be determined according to the terms of the headings of the tariff schedule and any relative section or chapter notes. In the event that the goods cannot be classified solely on the basis of GRI 1, and if the headings and legal notes do not otherwise require, the remaining GRIs 2 through 6 may then be applied in order.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (H350330).