The country of origin of a wheel hub unit
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Key passages, quoted from the ruling
- Therefore, the country of origin of the “G3 ball hub bearing unit” will be Thailand for marking purposes.
Ruling text
In your letter dated November 15, 2024, you requested a country of origin ruling on a wheel hub unit for marking purposes, on behalf of your client, R&S Automotive, Inc. The article under consideration is a wheel hub unit, which you refer to as a “G3 ball hub bearing unit.” It is a component of automotive wheels, which is connected to the axle through bearings, carrying the weight of the entire vehicle.
When the vehicle is in motion, the weight is transmitted to the ground through the wheel hub to support and stabilize the vehicle's movement. The wheel hub unit is connected to the engine through a transmission system (such as traditional drive shafts or modern electric drive systems), allowing the driving force generated by the engine to be converted into the rotational force of the wheels, thereby driving the vehicle forward or backward.
The wheel hub unit absorbs impacts and vibrations from uneven roads through its internal shock absorption system (such as suspension devices), protecting the vehicle and passengers from the impact of bumps and vibrations, and providing a comfortable driving experience. The wheel hub unit is composed of internal and external bearings, sealing rings, and other components.
According to your submission, the inner ring, outer ring (outer flange) and mandrel (inner flange) are made in Thailand, while the balls, cage, sealing ring, bolts, magnetic component, and grease are imported from China to Thailand for the final assembly. In Thailand, the Thai and Chinese components are cleaned, demagnetized, and laser marked. The bolts and pins are pressed into the flange. The inner groove is graded; steel balls are installed; and the oil is injected into the raceway.
Then, the components are pressed in together and riveted, which completes the assembly process.
Section 304 of the Tariff Act of 1930, as amended (19 U.S.C. 1304), provides that unless excepted, every article of foreign origin imported into the United States shall be marked in a conspicuous place as legibly, indelibly, and permanently as the nature of the article (or its container) will permit, in such a manner as to indicate to the ultimate purchaser in the United States, the English name of the country of origin of the article.
Congressional intent in enacting 19 U.S.C. 1304 was “that the ultimate purchaser should be able to know by an inspection of the marking on the imported goods the country of which the goods is the product. The evident purpose is to mark the goods so that at the time of purchase the ultimate purchaser may, by knowing where the goods were produced, be able to buy or refuse to buy them, if such marking should influence his will.” See United States v. Friedlander & Co., 27 C.C.P.A. 297, 302 (1940).
Part 134 of the U.S. Customs and Border Protection (“CBP”) Regulations (19 CFR 134) implements the country of origin marking requirements and exceptions of 19 U.S.C. 1304. Section 134.1(b), CBP Regulations (19 CFR 134.1(b)), defines “country of origin” as the country of manufacture, production, or growth of any article of foreign origin entering the United States.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N344082).