The country of origin of ignition coils for an automotive engine from Vietnam
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Ruling text
In your letter dated November 18, 2024, you requested a country of origin ruling determination on ignition coils for an automotive engine. In your request, you state that the ignition coils are completely assembled, and all subassemblies are manufactured in Vietnam. In your request, you presented documents/slides and a video showing the production work done in Vietnam. The item under consideration is described as part number DFC1007R (Ignition Coil), which is used to provide electrical energy to the spark plugs.
This product includes a plastic housing, copper wire, plastic skeleton, iron core, module, and rubber boot.
Your procedure for producing the ignition coil is the following: Material inspected for material, key dimension, appearance “First in First out” of temperature & humidity control Primary skeleton winding of .60mm copper wire to wind for 154±1 cycles (primary winding machine) Secondary skeleton winding using 0.05mm copper wire to wind for 10000±100 cycles (secondary winding machine) Install the high voltage connector and mounting diode Install tinned copper wire (length of tinned cooper is 30mm) Welded diode Solder the tinned copper wire Coil conduction test Put the primary coil into the secondary; install in the position Put the iron core into the assembled coil Install magnetic steel and measure the installation direction of magnetic steel Welding the PCB module onto the plug; non-virtual welding, electric soldering iron Module install into the coil, and make the secondary and primary coil's terminal weld Apply the Kraft glue K-704B onto the plastic housing Assembled coil installed into the housing Semi-product energy testing 14v, 1.4ms (tested to ≥26mJ) Preheating before potting 105℃~120℃ 2H; put the semi-coils into the preheating oven for 2hrs Put epoxy resin into the coil, put the epoxy resin into the coil when the vacuum degree≤100Mbar Epoxy resin cured at 80℃ ~125℃8H curing for 8hrs Finished products inspected Packaged Put the finished products into the warehouse When determining the country of origin for purposes of applying current trade remedies under Section 301, the substantial transformation analysis is applicable.
See, e.g., Headquarters Ruling Letter (“HQ”) H301619, dated November 6, 2018. The test for determining whether a substantial transformation will occur is whether an article emerges from a process with a new name, character, or use different from that possessed by the article prior to processing. See Texas Instruments Inc. v. United States, 681 F.2d 778 (C.C.P.A. 1982). This determination is based on the totality of the evidence.
See National Hand Tool Corp. v. United States, 16 C.I.T. 308 (1992), aff’d, 989 F.2d 1201 (Fed. Cir. 1993). With the facts and documentation presented, it is the opinion of this office that the Ignition Coil’s (Part # DFC1007R) components and subassemblies are substantially transformed during the manufacturing process in Vietnam and thus that the country of origin of the complete Ignition Coil for an automotive engine is Vietnam.
The holding set forth above applies only to the specific factual situation and merchandise description as identified in the ruling request.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N344129).