The tariff classification of steel sheets from South Korea
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Key passages, quoted from the ruling
- The applicable subheading for the steel sheet, part number 64312-AR000_BLK, will be 7326.19.0080, HTSUS, which provides for other articles of iron or steel: forged or stamped, but not further worked: other.
- The rate of duty will be 2.9 percent ad valorem.
Ruling text
In your letter dated November 27, 2024, you requested a tariff classification ruling on behalf of your client ILJITECH. Product descriptions and pictures were submitted for our review. The article under consideration is pre-cut steel sheet, which is a raw material, identified as part number 64312-AR000_BLK.
You indicated in your letter that prior to importation the raw material will undergo a blanking/stamping process performed in South Korea to produce the steel sheet in condition as imported into the United States.
You stated the raw material “goes through press processing (blanking) with a special mold made to match the width and thickness of the steel sheet…and cutting in the process is cutting to create the necessary parts (cutting in a state where there is no identifiable shape).” The blanking process produces individual steel sheets that measure 1680 millimeters in width by 630 millimeters in length, by 1.2 millimeters in thickness. The two parallel sides are not straight lines but have a wave shape.
Along the length each steel sheet has straight edge while along the width it has a wavy pattern. This product is shipped from South Korea after several sheets are stacked and packaged. Once imported the steel sheets will be further worked and used in the manufacture of automobiles parts. You proposed classification for part number 64312-AR000_BLK in subheading 7326.90.8688, Harmonized Tariff Schedule of the United States (HTSUS), which provides for other articles of iron or steel: other…other.
This office disagrees with your proposed classification. Heading 7326, HTSUS, provides for other articles of iron or steel.
The Explanatory Notes (EN) for 73.26 state that “This heading covers all iron or steel articles obtained by forging or punching, by cutting or stamping or by other processes such as folding, assembling, welding, turning, milling or perforating other than articles included in the preceding headings of this Chapter or covered by Note 1 to Section XV or included in Chapter 82 or 83 or more specifically covered elsewhere in the Nomenclature.” Since part number 64312-AR000_BLK is not more specifically provided for in any other heading of the tariff, the steel sheet would be classified in heading 7326, HTSUS, because the articles are not more specifically provided for in any other heading of the tariff.
Subheading Explanatory Note (EN) 7326.11 and 7326.19, HTSUS, states that after forging or stamping, the products of these subheadings may have been subjected to the following working or surface treatments: Removal of burrs, runouts and other stamping defects by rough burring, grinding, hammering, chiselling or filling; removal of annealing by acid dipping; simple sand blasting; roughing or rough bleaching and other operations intended exclusively to detect flaws in the metal; application of rough coatings of graphite, oil, tar, red lead or similar products, clearly intended to protect the subjects against rust or other types of oxidation; stamping, punching, printing, etc., with simple inscriptions, such as trademarks.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N344289).