Classification and country of origin determination for a bath rug; Section XI, Note 7(b); 19 CFR 102.21(c)(2); tariff shift
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Key passages, quoted from the ruling
- This is in reply to your letter dated December 11, 2024, requesting a classification and country of origin determination for a bath rug which will be imported into the United States.
- Item #EG2412001, a waffle weave bath rug, is classified under 5702.92.9000, HTSUS, and 9903.88.03, HTSUS.
Ruling text
This is in reply to your letter dated December 11, 2024, requesting a classification and country of origin determination for a bath rug which will be imported into the United States. You presented three samples representing various stages of production of the bath rug, Item #EG2412001. The samples will be retained for training purposes. FACTS: Sample 1 is a gray piece of fabric, measuring approximately 42 x 90 inches, of 100 percent polyester waffle weave construction.
The piece of fabric has regular breaks in the waffle weave pattern, approximately 1 ½ inches wide, where groups of weft yarns are loosely woven with groups of warp yarns. These breaks occur every 26 ½ inches. This same loosely woven pattern appears on the two selvedges using burgundy colored warp yarns. This piece of fabric, though representative of the fabric forming the completed article, produces a larger sized rug than Samples 2 and 3.
The spacing of the breaks in weave pattern occurs at shorter intervals for a 20 × 30 inch rug. Sample 2 is gray rug composed of 100 percent polyester woven waffle fabric. This item, measuring approximately 20 × 30 inches was cut from the fabric represented in Sample 1 along the areas of demarcation where there are breaks in the weave pattern resulting in all four edges having groups of weft yarns loosely woven with groups of warp yarns. The loosely woven warp yarns on the selvedge are green.
You state that these yarns mark where the factory should create the fringe. This rug has been heat treated which you state provides texture to the rug. Sample 3, Item #EG2412001, is a finished grey-green rug composed of 100 percent polyester woven waffle fabric. An application of hot melt glue is applied to the back of the rug to create a non-slip surface. The rugs are absent the loosely woven weft yarns from the areas of demarcation and the colored warp yarns found in Samples 1 and 2. All four edges are fringed.
The fringe is formed by removing the colored warp yarns and the loosely woven weft yarns that appear on Samples 1 and 2. The rectangular shaped rug measures 20 x 30 inches. The rug is intended to be used on the floor outside the bathtub or shower area while bathing. The samples identified, above, are indicated in parentheses, below, after the production step that results in the sample. The manufacturing operations for the bathmat are as follows: SCENARIO 1 China: The polyester waffle weave fabric is formed.
(Sample 1) The formed woven fabric is exported to Vietnam in rolls. Vietnam: The fabric is cut into pieces. The fabric is heat set. (Sample 2) The edges of the mat are unraveled to create the fringe. Hot melt glue is applied to the back. (Sample 3) Finished rug is packaged and exported to the United States. SCENARIO 2 China: The polyester waffle weave fabric is formed. (Sample 1) The fabric is cut into pieces. The cut pieces are heat set. (Sample 2) The heat set cut pieces are exported to Vietnam.
Vietnam: The edges of the mat are unraveled to create the fringe. Hot melt glue is applied to the back. (Sample 3) Finished rug is packaged and exported to the United States.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N344578).