The country of origin of an Ignition Coil assembled in Vietnam from Chinese components
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Ruling text
In your letter dated December 16, 2024, you requested a marking and country of origin ruling on an ignition coil for marking purposes and for purposes of applying trade remedies under Section 301, as amended, from China. In your request, you state that the ignition coil is completely assembled, and all subassemblies are manufactured in Vietnam. You presented documents/slides and a video showing the production work done in Vietnam.
The item under consideration is described as an Ignition Coil for an automotive engine, which is used to provide electrical energy to the spark plugs. This product includes a plastic housing, copper wire, plastic skeleton, iron core, module, and rubber boot.
Your procedure for producing the ignition coil is the following: Material inspected for material, key dimension, appearance “First in First out” of temperature & and humidity control Primary skeleton winding of 0.53mm copper wire to wind for 132±1 cycles (primary winding machine) Secondary skeleton winding using 0.05mm copper wire to wind for 9500±100 cycles (secondary winding machine) Install the high voltage connector and mounting diode Install tinned copper wire (length of tinned cooper is 30mm) Welded diode Solder the tinned copper wire Coil conduction test Put the primary coil into the secondary; install in the position Put the iron core into the assembled coil Install magnetic steel and measure the installation direction of magnetic steel Welding the PCB module onto the plug; non-virtual welding, electric soldering iron Module install into the coil, and make the secondary and primary coil's terminal weld Apply the Kraft glue K-704B onto the plastic housing Assembled coil installed into the housing Semi-product energy testing 14v, 1.4ms (tested to ≥26mJ) Preheating before potting 105℃~120℃ 2H; put the semi-coils into the preheating oven for 2hrs hours Put epoxy resin into the coil, put the epoxy resin into the coil when the vacuum degree≤100Mbar Epoxy resin cured at 80℃ ~125℃8H curing for 8hrs hours Finished products inspected Packaged Put the finished products into the warehouse When determining the country of origin for purposes of applying current trade remedies under Section 301, the substantial transformation analysis is applicable.
See, e.g., Headquarters Ruling Letter (“HQ”) H301619, dated November 6, 2018. The test for determining whether a substantial transformation will occur is whether an article emerges from a process with a new name, character, or use different from that possessed by the article prior to processing. See Texas Instruments Inc. v. United States, 681 F.2d 778 (C.C.P.A. 1982). This determination is based on the totality of the evidence.
See National Hand Tool Corp. v. United States, 16 C.I.T. 308 (1992), aff’d, 989 F.2d 1201 (Fed. Cir. 1993).
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N344657).