The country of origin of automotive radiators
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Ruling text
In your letter dated January 6, 2025, you requested a country of origin ruling for purposes of applying trade remedies under Section 301, as amended, from China, on two lines of radiators, which you filed on behalf of REACH International, Inc. The articles under consideration are Radiators With Oil Cooler, Model Numbers 1.41.13062.126 and 1.41.13204.126, Radiators Without Oil Cooler, Model Numbers 1.41.2370.126, 1.41.2423.126, and 1.41.2791.126, which are essential parts of a car’s cooling system.
The radiators help regulate the engine's temperature and prevent damage. Radiators work by venting excess heat away from the engine through a process of releasing coolant and water, absorbing heat and then cooling it down with air from outside the vehicle. An automotive radiator is located under the hood and in front of the engine, with the coolant reservoir located nearby. You state that the main parts of a radiator include the core, inlet and outlet tanks, and pressure cap.
The core is the largest part of the radiator. It features the metal cooling fins that help vent the air. The core is where hot liquid releases heat and gets cooled before being sent through the process again. The inlet and outlet tanks are where coolant flows in and out of the radiator and are located in the radiator head. Hot liquid flows from the engine through the inlet tank, and once it is cooled, goes out through the outlet tank and back into the engine.
The pressure cap works to help seal the cooling system so it can remain pressurized. Coolant in the radiator is pressurized to prevent the coolant from boiling. It also keeps the system more efficient. According to the information you provided, the tank, gasket, head plate, flat aluminum material, side plate, other accessories, and the oil coolant, when applicable, are imported into Thailand from China.
In Thailand, the Chinese-origin raw aluminum is folded, rolled, and cut to length to form welded flat tubes in a special welding tube machine. To manufacture the fins, the Chinese origin raw aluminum is sent through another machine where it is formed, compressed, and cut to length to create the fins. The radiator core is fabricated by assembling the welded flat tubes and cooling fins in alternating layers. Once the desired length of the core is achieved, header plates and side plates are joined tightly to the core.
After fabrication, the radiator core must undergo a brazing process to ensure that all joints and spaces are tightened together and sealed to prevent any fluid leaks. Aluminum brazing is a process of joining two or more aluminum pieces together using a filler metal that melts at a lower temperature than the base metal. The filler metal is typically made of aluminum-silicon alloys, which have a lower melting point than the base metal.
The process involves heating the aluminum pieces to a temperature above the melting point of the filler metal but below the melting point of the base metal. The molten filler metal flows into the joint and forms a bond between the two pieces of aluminum. Once the radiator core is assembled and brazed, an initial leak test is conducted.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N344961).