The country of origin of ball joints
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Key passages, quoted from the ruling
- Therefore, the country of origin for the Model 1 (Part Number YQ0051) and Model 2 (Part Number XQ10558) ball joints will be Thailand for marking purposes.
Ruling text
In your letter dated January 21, 2025, you requested a country of origin ruling on ball joints. The subject merchandise are Model 1 (Part Number YQ0051) and Model 2 (Part Number XQ10558) ball joints, which are designed to be used in passenger vehicle suspension systems. The ball joints are slightly different in their shape to fit different vehicle types. Model 1 contains a cylindrical housing, while Model 2 contains a flanged housing and a special nut. However, they follow the same production steps.
Ball joints are a critical component in the suspension system of an automobile. They provide the necessary flexibility, support, and alignment to ensure a smooth and controlled driving experience. Additionally, ball joints act as pivot points for the steering system, allowing the wheels to turn left and right. Ball joints also support the weight of the vehicle while allowing the suspension to move vertically.
According to the information supplied with your request, the ball joints consist of a ball pin, housing, dust boot, end cap, snap ring, clip ring, grease, bearing, and nut. The ball pin blank and cylindrical/flanged housing blank are forged in China from steel bars, and imported to Thailand for further processing.
In Thailand, the ball pin forging undergoes flat head end face and rough turning, flat length and lead center hole drilling, rod finish turning, head rough turning, pin hole drilling and milling, thread rolling, induction hardening, crack detection, finish coating, and polishing. Similarly, in Thailand the cylindrical housing forging undergoes flat face and turning, flat length and lead center hole drilling, rough inner hole drilling, finish turning, knurling, induction hardening, and surface treatment.
The flanged housing forging undergoes rough and precise machining on the big hole and small holes, heat treatment, finish coating, and screw tapping. The end cap is made in Thailand from left over steel sheet scraps from China by stretching, forming, punching, finish coating, and laser marking.
The finished ball pin, housing, and end cap are then combined together with the Thai sourced dust boot, grease, and bearing, and the Chinese sourced snap ring, clip ring, and nut (including the special nut for Model 2) to form the finished ball joint.
Section 304 of the Tariff Act of 1930, as amended (19 U.S.C. 1304), provides that unless excepted, every article of foreign origin imported into the United States shall be marked in a conspicuous place as legibly, indelibly, and permanently as the nature of the article (or its container) will permit, in such a manner as to indicate to the ultimate purchaser in the United States, the English name of the country of origin of the article.
Congressional intent in enacting 19 U.S.C. 1304 was “that the ultimate purchaser should be able to know by an inspection of the marking on the imported goods the country of which the goods is the product. The evident purpose is to mark the goods so that at the time of purchase the ultimate purchaser may, by knowing where the goods were produced, be able to buy or refuse to buy them, if such marking should influence his will.” See United States v.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N345286).