The country of origin of a yacht
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Key passages, quoted from the ruling
- Therefore, the country of origin of the Nordhavn 80 yacht will be Taiwan for Section 301 and marking purposes.
Ruling text
In your letter dated January 21, 2025, filed on behalf of Pacific Asian Enterprises, Inc., you requested a ruling on the applicability of Section 301 trade remedies and country of origin marking for a Nordhavn 80 yacht. The article under consideration is the Norhavn 80 yacht, built in Taiwan and China.
The hull or superstructure of the yacht is manufactured in Taiwan of fiberglass reinforced plastic or “FRP.” The construction of a FRP yacht uses a series of molds for the hull, the decks, the fuel tanks, waste tanks, and water tanks. These molds are an actual sized construction of the yacht that are female, made from tooling which is an actual size wood frame of the Nordhavn yacht.
The molds are prepared for construction with a machine buffing, and layers of wax are applied to the surface to ease the eventual release of the part from the mold. After this, many layers of laminate, which is fiberglass that has been wetted with resin, is then laid by hand into the mold and rolled out. The layers are added according to a schedule to engineer in the appropriate strength. The hull of a Nordhavn consists of the bow, the bulbous bow, the hull, the keel, the rudder shoe, and the stern.
This is considered or referred to the ‘stem to stern’ of a yacht. While the hull is in the mold, there are engineered stringers that are added into the hull by laminating them to the hull structure to provide additional strength. Once the stringers are added bulkheads will be laminated into the hull structure at the specified (engineered) locations. The tanks and the decks are laminated using molds and the same procedure as above.
Once the hull, the tanks and decks are cured the tanks are added into the hull, and further parts are added into the hull. The next step is joining the decks to the hull. The main decks are a continuous fiberglass laminate, stem to stern, adding to the strength and level of finish. The wheelhouse, Portuguese bridge, salon and bulwarks are also crated in a single mold for a strong joint-free structure.
You state in your letter and then confirmed in your correspondence, dated February 12, 2025, that when the yacht departs Taiwan for China, the engines from the United States and the stabilization system have already been installed.
The labor performed in China is to finish the interior woodwork, install the cabinetry, the stone counter tops, the stone floors, finish painting the interior, finish the plumbing and wiring, and install the appliances, such as a washer, dryer, stove, oven, refrigerator, coffee maker, and a wine cooler, parts, and accessories. The vessel’s pre-wiring and plumbing was already performed in Taiwan. The shafts and propellors were made in the USA and installed in China.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N345287).