The country of origin of ignition coils for an automotive engine
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Ruling text
In your letter dated January 22, 2025, you requested a country of origin ruling determination on ignition coils for marking purposes and for purposes of applying trade remedies under Section 301, as amended from China In your request, you state that the ignition coils and all subassemblies are manufactured in Thailand with components from China and Thailand. You presented documents/slides showing the production work done in Thailand.
The item under consideration is described as part number IG-9005 (Ignition Coil), which is used to provide electrical energy to the spark plugs. This product includes a plastic housing, copper wire, plastic skeleton, iron core, module, and rubber boot.
Your procedure for producing the ignition coil is the following: · Secondary winding of copper wires on plastic bobbin, to make secondary coils · Primary winding (Winding primary wire on primary bobbin, to make primary coils · Assembly process (Assembly primary coils, secondary coils and iron core) · Iron core assembly · Put coils into housing · Soldering coils group (Soldering with housing) · Prepare prior to potting · Potting epoxy resin · Epoxy resin drying · Assembly rubber boot and spring · Inductance and resistance tests for finished parts · Output voltage test for finished parts · Finished parts inspection · Laser coding · Package for parts · Stock finished parts in warehouse and ready for shipment When determining the country of origin for purposes of applying current trade remedies under Section 301, the substantial transformation analysis is applicable.
See, e.g., Headquarters Ruling Letter (“HQ”) H301619, dated November 6, 2018. The test for determining whether a substantial transformation will occur is whether an article emerges from a process with a new name, character, or use different from that possessed by the article prior to processing. See Texas Instruments Inc. v. United States, 681 F.2d 778 (C.C.P.A. 1982). This determination is based on the totality of the evidence.
See National Hand Tool Corp. v. United States, 16 C.I.T. 308 (1992), aff’d, 989 F.2d 1201 (Fed. Cir. 1993).
Additionally, Section 304 of the Tariff Act of 1930, as amended (19 U.S.C. 1304), provides that unless excepted, every article of foreign origin imported into the United States shall be marked in a conspicuous place as legibly, indelibly, and permanently as the nature of the article (or its container) will permit, in such a manner as to indicate to the ultimate purchaser in the United States, the English name of the country of origin of the article.
Congressional intent in enacting 19 U.S.C. 1304 was “that the ultimate purchaser should be able to know by an inspection of the marking on the imported goods the country of which the goods is the product. The evident purpose is to mark the goods so that at the time of purchase the ultimate purchaser may, by knowing where the goods were produced, be able to buy or refuse to buy them, if such marking should influence his will.” See United States v. Friedlander & Co., 27 C.C.P.A. 297, 302 (1940). Part 134 of the U.S.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N345322).