The country of origin of NanoCure
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Key passages, quoted from the ruling
- Accordingly, the country of origin of the NanoCure will be Mexico for purposes of applying trade remedies under Section 301.
Ruling text
In your letter dated January 24, 2025, you requested a country of origin ruling on the SprintRay NanoCure on behalf of SprintRay Inc. The SprintRay NanoCure is a post-curing device measuring 7.9 x 8 x 13.5 in. (W x D x H) that uses two wavelength (365 nm and 385 nm) LED lights to cure 3D printed dental appliances. It is designed for dental offices, enabling practitioners to have a curing device chairside.
The device utilizes a combination of ultraviolet (UV) light and heat to transition 3D printed parts from their initial “green state,” where polymerization is incomplete, to a fully cured final state. The main components of the device are identified as a motherboard, a UV panel, a heater, and a fan. The NanoCure is designed and developed in the United States. Components from various countries are fully assembled in Mexico.
Motherboard Production in Mexico: The Motherboard is equipped with an Android-based operating system and serves as the central processing unit, housing the curing logic for the device. It regulates the sequence and duration of UV light and heat application through communication with the driver board using the UART (Universal Asynchronous Receiver/Transmitter) communication protocol.
The mother board functions as the “brains” of the NanoCure containing the logic and controls required to deliver the advanced synchronization of UV light, heat, and thermal management. In Mexico, 257 electronic components from several countries are assembled to the motherboard using Surface Mount Technology (SMT). Then the motherboard undergoes stringent quality control processes including advanced X-ray and Automated Optical Inspection (AOI) technologies.
Software and firmware, developed in the United States, are installed on the motherboard in Mexico, enabling the NanoCure to achieve full functionality. UV Panel Production in Mexico: The UV Panel functions as the primary curing source, initiating the photopolymerization process to advance the curing of the 3D printed parts. The UV panel consists of four side UV boards and two center UV boards with pillars for thermal management.
Each board is produced by assembling LEDs, temperature sensors, and connectors onto a bare PCB (printed circuit board) using SMT. Once assembled, the printed circuit board assembly (PCBA) undergoes stringent quality control processes.
The lamp panel sub-assembly in Mexico: The side and center UV boards are assembled with Chinese-origin heat sinks, heat transfer plates (thermal pads), windshielding plates, screws, over-temperature protection switch (top over-temperature protection sensor), and lower lamp panel over-temperature protection switch (bottom over- temperature protection sensor) into a lamp panel sub-assembly.
The fan sub-assembly in Mexico: A fan, a motherboard tower, nuts, and screws are sourced from China and assembled into a fan sub-assembly in Mexico.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N345397).