The country of origin of a garage door opener set
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Key passages, quoted from the ruling
- Thus, based on the totality of the circumstances, the country of origin of the EasyRoller14 Operator set, as described above, will be China.
Ruling text
In your letter dated February 3, 2025, you requested a country of origin ruling on the EasyRoller14 Operator on behalf of your client, Automatic Technology America LLC. The EasyRoller14 Operator is identified as an automatic garage door opener for rolling sheet doors. It is intended for commercial applications and imported as a set containing a main operator unit, wall transmitter, remote control transmitters, and photo electric safety beams.
The remote control transmitters are used to wirelessly open and close the rolling sheet door. The wall transmitter serves the same purpose but can operate as either a wired or wireless device. The components for the EasyRoller14 Operator set are consolidated, assembled, and programmed in Australia. The remote control transmitters, wall transmitter, and photo electric safety beams are sourced from China as pre-built units. The main operator unit contains a drive system to open or close the garage door.
It is assembled in Australia using Chinese subassemblies, including a printed circuit board assembly, power drive assembly, support chassis assembly, light diffuser, and string handle assembly. These subassemblies are sourced from China in a preassembled condition. For example, the power drive assembly is a pre-built unit with a 600N DC clutch gear motor, transformer, EMI filter board, and power cord installed in a plastic housing.
The support chassis assembly arrives in Australia in a similar condition, with a timing assembly, rope buckle, and more, installed in a housing. In Australia, firmware is loaded onto the printed circuit board assembly for the main operator unit. Next, a worker connects the power drive assembly, transformer, timing assembly, power cord assembly, beam connector, and light diffuser assembly to the printed circuit board assembly.
These steps are largely described as feeding wires, completing electrical connections, installing support plates, fitting pieces in place, attaching covers, and securing the subassemblies using fasteners or cable ties. Afterwards, the handle string is attached and tested. The resulting subassembly is placed inside a plastic housing and the entire unit is tested.
The remote control transmitters and wall transmitter are programmed and coded to the main operator unit before the individual items are packaged together for shipment. When determining the country of origin for purposes of applying current trade remedies under Section 301, the substantial transformation analysis is applicable. See, e.g., Headquarters Ruling Letter H301619, dated November 6, 2018.
The test for determining whether a substantial transformation will occur is whether an article emerges from a process with a new name, character, or use different from that possessed by the article prior to processing. See Texas Instruments Inc. v. United States, 681 F.2d 778 (C.C.P.A. 1982). This determination is based on the totality of the evidence. See National Hand Tool Corp. v. United States, 16 C.I.T. 308 (1992), aff’d, 989 F.2d 1201 (Fed. Cir. 1993).
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N345644).