The country of origin marking of non-prescription eyewear
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Ruling text
This is in response to your letter dated February 16, 2025, requesting a ruling on whether the proposed marking of “Made in Country Indicated on Eyewear” printed on the tag is an acceptable country of origin marking for the subject non-prescription eyewear. A marked sample was submitted with your letter for review.
In your request, you state that FGX will import non-prescription reading glasses and sunglasses from various countries, including China, and are sold at retail stores throughout the U.S. Per the presented sample, the subject glasses are marked on the inside of one arm with the country of origin. The glasses are then attached to a carboard hanging tag designed to allow the glasses to be hung from a rack at the store.
On the back of the tag will be the word “Distributed by: FGX International Inc. Smithfield, RI 02917 USA.” Directly below this statement will be the words “Made in the Country Indicated on Eyewear.” The marking statute, section 304, Tariff Act of 1930, as amended (19 U.S.C. 1304), provides that, unless excepted, every article of foreign origin (or its container) imported into the U.S. shall be marked in a conspicuous place as legibly, indelibly and permanently as the nature of the article (or container) will permit, in such manner as to indicate to an ultimate purchaser in the U.S. the English name of the country of origin of the article.
Section 134.1(d), defines the term “ultimate purchaser” as “generally the last person in the United States who will receive the article in the form in which it was imported.” As provided in section 134.41(b), Customs Regulations (19 CFR 134.41(b)), the country of origin marking is considered conspicuous if the ultimate purchaser in the U.S. is able to find the marking easily and read it without strain.
With regard to the permanency of a marking, section 134.41(a), Customs Regulations (19 CFR 134.41(a)), provides that as a general rule marking requirements are best met by marking worked into the article at the time of manufacture. For example, it is suggested that the country of origin on metal articles be die sunk, molded or etched.
Section 134.44, Customs Regulations (19 CFR 134.44), provides that markings must be legible and sufficiently permanent so that it will remain on the article (or its container when the container and not the article is required to be marked) until it reaches the ultimate purchaser.
Under section 134.46, Customs Regulations (19 CFR 134.46), in any case in which the name of any foreign country or locality other than the country or locality in which the article was manufactured or produced, appear on an imported article or its container, there shall appear, legibly and permanently, in close proximity to such words, letters or name, and in at least a comparable size, the name of the country of origin preceded by "Made in," "Product of," or other words of similar meaning.
Based upon the information provided, including the samples, the marking of the country of origin that is printed on the inside of the arm, is sufficiently legible, indelible, permanent, and conspicuous to satisfy the marking requirements set forth in 19 U.S.C. 1304 and 19 CFR Part 134.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N345994).