The country of origin of a fuel injector
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Ruling text
In your letter dated February 21, 2025, you requested a country of origin ruling for a fuel injector. Descriptive information was included in the submission. The product in question is referred to as a fuel injector. The fuel injector is a solenoid valve that consists of a body that primarily encases a ball valve, a valve seat, an orifice plate, and a spring. The solenoid valve controls the flow of fuel into the fuel supply system of a motor vehicle.
The injector is designed to connect to a fuel rail and an intake manifold. Concerning the origin of the fuel injector, you state that it will be assembled in Thailand from components that originate in Japan, Thailand, and China. The following processes occur in Thailand prior to the final assembly. A hole is drilled into the circular shaped plate to create a plate with an orifice. Less than five percent of material is removed.
To produce the solenoid actuator, pins manufactured in China are connected to wires and inserted into a Thai-manufactured bobbin. The necessary winding process occurs. The components are then welded in place. To produce a valve subassembly, a ball of Japanese origin is welded to a Thai-manufactured armature. The ball is then subjected to a grinding process. Afterward, a filter, which is of Chinese origin, is positioned in place.
The final assembly process begins with the installation of a Thai magnetic ring and a Chinese adjust tube into a core produced in Thailand. Then, an inlet tube, a non-magnetic tube and a guide tube, all from Thailand, are connected and welded to the core. Next, a solenoid, along with a magnetic cap and ring, which are both manufactured in Thailand, are installed to the core and welded in place. A plastic piece produced in Thailand is placed over the solenoid.
Afterwards, an orifice plate is welded to a Thai-manufactured valve seat and these connected components are installed into the housing. Additional components are then installed into the housing, which includes the valve subassembly and a Chinese spring. Once these components are adjusted, they are welded into position. Upon completion, the finished fuel injector undergoes various testing. When determining the country of origin, the substantial transformation analysis is applicable.
See, e.g., Headquarters Ruling Letter H301619, dated November 6, 2018. The test for determining whether a substantial transformation will occur is whether an article emerges from a process with a new name, character, or use different from that possessed by the article prior to processing. See Texas Instruments Inc. v. United States, 681 F.2d 778 (C.C.P.A. 1982). This determination is based on the totality of the evidence.
See National Hand Tool Corp. v. United States, 16 C.I.T. 308 (1992), aff?d, 989 F.2d 1201 (Fed. Cir. 1993). In this instance, components from Japan, China and Thailand are assembled together in Thailand to form subassemblies that are affixed to additional components from China and Thailand to produce a fuel injector.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N346169).