The country of origin of fuel modules
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Ruling text
In your letter dated March 4, 2025, you requested a country of origin ruling on fuel modules. Descriptive information was provided with your submission. The products at issue are referred to as a fuel pump and fuel modules, identified by model numbers JINJIA-A75-13, JINJIA-A803-14, JINJIA-A779, JINJIA-A195ZL and JINJIA-B7. The modules primarily consist of a fuel pump, a float arm, a wiper seat. an ROV valve, a pressure sensor, a reservoir with a jet pump, and a resistance card seat.
The fuel pump and the additional components work together to deliver fuel from the fuel tank to the engine management system. In regard to origin, you explain that components from China and Thailand are assembled together to form subassemblies. The subassemblies are then combined with one another to form the final product. The processes that produce the subassemblies and the final assembly processes occur in Thailand. For the flange subassembly, a supply tube is pressed on the flange and fastened in place.
An O-ring is then installed, a support rod is pressed onto the flange, and a spring support is installed onto the support rod. Tests are completed throughout the steps. For the reservoir subassembly, a filter element and cover are welded into the filter bucket. Next a pressure regulator is inserted into the regulator seat of the filter. The buckle is locked, and a hose is pressed onto the filter’s pipe outlet. The filter and pump are pressed into their respective holder and locked in placed.
Afterwards, the strainer is connected to the pump’s inlet pipe and the pump holder with the contained components are pressed into the reservoir. Subsequently, an O-ring is installed, and the wire harness is appropriately welded. A check valve is assembled, and then the valve and a spring are installed into a jet pump, which is subsequently installed into the reservoir. For the resistance subassembly, the resistance card is assembled to the wiper seat.
For the float arm subassembly, a float, a float block and washer are assembled to each other. Once the aforementioned subassemblies are complete, the final assembly of the fuel modules occurs. During the final assembly, the flange subassembly is inserted into the reservoir subassembly. Next, the resistance subassembly and the float subassembly are secured onto the reservoir subassembly and buckled in place. The difference between the five products is the origin of the components.
For JINJIA-A195ZL, the Chinese components are a dust cover (part number 405021010062), a pressure sensor, a ROV valve, a support rod and spring, a strainer, a resistance card, a float arm, and a wire harness. For JINJIA-A75-13, the Chinese components are a flange, a support rod and spring, a strainer, a float arm, a resistance card, a contact point and a wire harness.
For JINJIA-A779, the Chinese components are a flange, a support rod and spring, a pressure regulator, a resistance card, a float arm, and a wire harness. For JINJIA-A803-14, the Chinese components are a flange, a support rod and spring, a pressure regulator, a resistance card, and a wire harness. For the JINJIA-B7, the Chinese components are an armature and an impeller.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N346435).