The tariff classification of finished aluminum heatsinks for plasma arc cutting machines from China
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Key passages, quoted from the ruling
- The general rate of duty will be 4.7 percent ad valorem.
Ruling text
In your letter dated March 25, 2025, you requested a tariff classification ruling on finished aluminum heatsinks for plasma arc cutting machines from China. Technical information was submitted with your request. The items under consideration are described as finished aluminum heatsinks (eight models) for incorporation into various Powermax plasma arc cutting machines. Specifically, each heatsink will be affixed to the printed circuit board assembly (PCBA) in the power supply’s start circuit subassembly.
During operation, the heatsink absorbs heat generated by the PCBA and redistributes it to the side of the machine to enhance cooling and prevent overheating. Each heatsink accomplishes this largely by the action of cooling fins which increase surface area, improve airflow, and enhance thermal conductivity. In some cases, the subject heatsinks also provide a mechanical dust barrier for sensitive electronic components.
The heatsinks are primarily made of extruded aluminum that undergoes additional processing to precise specifications and tolerances. Cooling fin count, shape, and spacing are uniquely calculated based on stress and environmental testing, including conductive and convective heat transfer analysis. Depending on the unique heat load of each model of plasma arc cutting machine, the cooling fins vary in shape, height, and thickness.
In addition, pockets and tapped drill holes are machined on the back side of the heatsinks for mounting and to provide proper spacing with electrical components such as capacitors and transducers. Furthermore, the heatsinks are ground or fly cut on both sides to a precise surface finish to maintain proper contact with the PCBA. You state that each finished aluminum heatsink is essential for operation and can only be used with the corresponding Powermax plasma arc cutting machine for which it was designed.
In your letter, you propose classification of the finished aluminum heatsinks in subheading 8466.93.9885, Harmonized Tariff Schedule of the United States (HTSUS). We agree.
The applicable subheading for the finished aluminum heatsinks for plasma arc cutting machines will be 8466.93.9885, HTSUS, which provides for Parts and accessories suitable for use solely or principally with the machines of headings 8456 to 8465, including work or tool holders, self-opening dieheads, dividing heads and other special attachments for the machines; tool holders for any type of tool for working in the hand: Other: For machines of headings 8456 to 8461: Other: Other: Other: Other: Other: Other.
The general rate of duty will be 4.7 percent ad valorem. Effective March 4, 2025, pursuant to U.S. Note 2(u) to Subchapter III, Chapter 99, all products of China and Hong Kong as provided by heading 9903.01.24, HTSUS, other than products classifiable under headings 9903.01.21, 9903.01.22, and 9903.01.23, HTSUS, will be subject to an additional 20 percent ad valorem rate of duty.
At the time of entry, you must report the applicable Chapter 99 heading, i.e. 9903.01.24, in addition to subheading 8466.93.9885, HTSUS, listed above.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N347079).