The country of origin of diodes
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Ruling text
In your letter dated April 1, 2025, you requested a country of origin ruling on various diodes. The items concerned are “Surface-Mount Mixer/Detector Schottky Diodes” (product codes SMSA7630-993LF and SMSA3923-011LF) and “Surface-Mount Silicon Varactor Diode” (product code SMVA1400-611LF). The SMSA7630-993LF and the SMSA3923-011LF surface-mountable, plastic-packaged silicon Schottky diodes are designed for low-power and low-noise signal detection in automotive applications including microwave mixers and detectors.
The SMVA1400-611LF surface-mountable, plastic-packaged silicon varactor diode is designed for use in automotive applications, such as voltage-controlled oscillators, to tune signals to the right frequency, and in Phase-Locked Loops for RF signal stabilization. Each diode undergoes a front-end and back-end manufacturing processing.
The front-end manufacturing processes take place in the United States and consist of altering a raw wafer or substrate with the following processes: Oxide/Nitride/Metal deposition Photolithography Etching Metal deposition Wafer thinning Manual and on-wafer (die) testing Automated visual inspection The back-end manufacturing processes take place in China and consist of the following steps: Multiple quality check/inspection/testing stages Verifying the device information in the assembly instruction matches the material (wafer) being assembled Wafer mounting Sawing into individual die Die packaging Multiple baking/curing stages Wire bonding the diode contacts to the lead frame of the end device package Molding/encapsulating Removing excess material Backside marking (for SMVA1400-611LF and SMSA3923-011LF) Plating Forming The front-end manufacturing processing, particularly wafer fabrication steps like oxide/nitride/metal deposition, etching, and photolithography are key steps to make each diode functional.
Once the front-end manufacturing process is complete, the diode has all the necessary elements to function as intended. The basic functionality of the diodes is not dependent upon the back-end manufacturing process. When determining the country of origin for purposes of applying current trade remedies under Section 301, the substantial transformation analysis is applicable. See, e.g., Headquarters Ruling Letter H301619, dated November 6, 2018.
The test for determining whether a substantial transformation will occur is whether an article emerges from a process with a new name, character, or use different from that possessed by the article prior to processing. See Texas Instruments Inc. v. United States, 681 F.2d 778 (C.C.P.A. 1982). This determination is based on the totality of the evidence. See National Hand Tool Corp. v. United States, 16 C.I.T. 308 (1992), aff’d, 989 F.2d 1201 (Fed. Cir. 1993).
Based upon the facts presented, it is the opinion of this office that the front-end processing that takes place in the United States is both meaningful and complex, resulting in the creation of wafers which incorporate numerous finished diode chips/die. The character of the finished/packaged diodes is imparted by the diode chip/die (which was formed on the wafer).
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N347292).