The tariff classification of multilayer wood flooring panels from the Czech Republic
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Key passages, quoted from the ruling
- The rate of duty will be 8 percent ad valorem.
Ruling text
In your letter, dated April 9, 2025, you requested a binding tariff classification ruling. The ruling was requested on multilayer wood flooring panels. Product information and photos were submitted for our review. The product under consideration is a multilayer wood flooring panel. The flooring panel is constructed of 3 wood plies. The face ply, measuring less than 4mm in thickness, consists of a continuous sheet of Oak (Quercus spp., a non-coniferous wood) wood veneer.
The center ply, measuring approximately 10mm in thickness, consists of strips of spruce (Picea spp., a coniferous wood) wood. The back ply, measuring approximately 1mm in thickness, consists of spruce veneer. The grain of the center ply runs at a 90-degree angle to that of the face and back plies. The surface of the face ply is unfinished. The panel is tongued and grooved on its edges and ends.
In understanding the language of the Harmonized Tariff Schedule of the United States (HTSUS), the Explanatory Notes to the Harmonized System (ENs) may be utilized. The ENs, although not dispositive nor legally binding, provide a commentary on the scope of each heading of the HTSUS, and are the official interpretation of the Harmonized System at the international level.
See T.D. 89-80, 54 Fed. Reg. 35127, 35128 (August 23, 1989). “Plywood” is defined in the ENs for heading 4412, HTSUS: a panel “consisting of three or more sheets of wood glued and pressed one on the other and generally disposed so that the grains of successive layers are at an angle.” This definition describes the instant panels.
The ENs also describe “blockboard” as panels “in which the core is thick and composed of blocks, laths or battens of wood glued together and surfaced with the outer plies.” This also describes the instant panels. Both plywood and blockboard are specifically provided for in heading 4412 of the HTSUS.
The applicable subheading for the multilayer wood flooring panels with face and back ply of oak, will be 4412.52.3105, HTSUS, which provides for Plywood, veneered panels and similar laminated wood: Blockboard, laminboard and battenboard: Other (than With at least one outer ply of tropical wood), with at least one outer ply of nonconiferous wood: Plywood: Not surface covered, or surface covered with a clear or transparent material which does not obscure the grain, texture or markings of the face ply: Other: Wood flooring.
The rate of duty will be 8 percent ad valorem. Effective April 5, 2025, Executive Orders implemented ?Reciprocal Tariffs.? All imported merchandise must be reported with either the Chapter 99 provision under which the reciprocal tariff applies or one of the Chapter 99 provisions covering exceptions to the reciprocal tariffs. Products of China, including Hong Kong and Macau, will be assessed an additional ad valorem rate of duty of 125 percent.
Products from all other countries, including the Czech Republic, will be subject to an additional 10 percent ad valorem rate of duty. At the time of entry, you must report the Chapter 99 heading applicable to your product classification, i.e. 9903.01.25, in addition to subheading 4412.52.3105, HTSUS, listed above.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N347607).