The country of origin of plywood panels
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Ruling text
In your letter, dated March 21, 2025, you requested a binding country of origin ruling on plywood panels. The ruling was returned to you for additional information, which was received by this office on April 11, 2025. Product information and a sample were submitted for our review. The product under consideration is plywood panels manufactured in multiple countries.
The plywood consists of 11 core layers (veneers) of eucalyptus (a non-coniferous wood), a layer of okoume (a tropical wood) on each side of the eucalyptus, and an oak veneer applied as a face to one layer of okoume. The grain of each veneer runs at a 90-degree angle to that of the adjacent veneers, with the exception of the oak, which is parallel to the okoume veneer beneath it. The panel is unfinished, i.e., not coated on its surfaces with any material.
In understanding the language of the Harmonized Tariff Schedule of the United States (HTSUS), the Explanatory Notes to the Harmonized System (ENs) may be utilized. The ENs, although not dispositive nor legally binding, provide a commentary on the scope of each heading of the HTSUS, and are the official interpretation of the Harmonized System at the international level. See T.D. 89-80, 54 Fed. Reg. 35127, 35128 (August 23, 1989).
The ENs define “plywood” as panels “consisting of three or more sheets of wood glued and pressed one on the other and generally disposed so that the grains of successive layers are at an angle.” The instant panel meets the definition of “plywood” as it consists of 14 layers and virtually all of the layers are disposed so that the grains of successive layers are at a 90-degree angle.
We note that the definition requires that the grains “generally” be at an angle to successive layers; the oak layer is parallel to the adjacent layer, but this is not significant enough to yield a product that has properties that are different from plywood. You argue that the panel is a “veneered panel”.
A “veneered panel” is defined in the ENs as a panel “consisting of a thin veneer of wood affixed to a base, usually of inferior wood, by glueing under pressure.” “Veneered panel” is a less specific product than plywood. It is merely a veneer affixed to a base, whereas plywood is a veneered panel with a specific arrangement of layers. “Plywood” is a more specific product than a “veneered panel”, and the instant panel meets the definition of plywood.
The applicable subheading for the instant panel will be 4412.31.4869, HTSUS, which provides for Plywood, veneered panels and similar laminated wood: Other plywood consisting solely of sheets of wood (other than bamboo), each ply not exceeding 6 mm in thickness: With at least one outer ply of tropical wood: Not surface covered, or surface covered with a clear or transparent material which does not obscure the grain, texture or markings of the face ply: Other: With at least one outer ply of the following tropical woods: Dark Red Meranti, Light Red Meranti, White Lauan, Sipo, Limba, Okoumé, Obeche, Acajou d'Afrique, Sapelli, Virola, Mahogany, Palissandre de Para, Palissandre de Rio or Palissandre de Rose: Other: Other: Not surface covered: Other.
The rate of duty is 8 percent.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N347656).