The country of origin of a ball joint
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Key passages, quoted from the ruling
- Therefore, the country of origin for the ball joint (Part Number RBL-6241) will be Thailand for marking purposes.
Ruling text
In your letter dated April 14, 2025, you requested a country of origin ruling on a ball joint for marking purposes. The article under consideration is a Ball Joint (Part Number RBL-6241), which is a critical component in the suspension system of an automobile. It provides the necessary flexibility, support, and alignment to ensure a smooth and controlled driving experience. Additionally, the ball joint acts as pivot points for the steering system, allowing the wheels to turn left and right.
The ball joint also supports the weight of the vehicle while allowing the suspension to move vertically. You state that the ball joint consists of the following components: a ball stud, dust cover, clamping 1 and 2, snap ring, bearing, protect cover, cover plate, nut, ball housing, and grease, which you source from China and import to Thailand for further processing. The ball stud and ball housing arrive to Thailand in a form of incomplete forgings, while the rest of the components arrive in their finished state.
In Thailand, the ball stud forging undergoes tempering (heat treatment); machining process involving ball head rough turning, shank rough turning, undercut rough turning, ball head finish turning, shank finish turning, and undercut finish turning; and surface treatment, involving degreasing, water washing, pickling, water washing, activating the surface with an acidic activator, trivalent chromium plating, water washing, passivation, water washing, drying, inspection, and packaging.
The ball housing forging undergoes tempering (heat treatment), machining: rough turning and fine turning of the housing, and surface treatment: E-coating, degreasing, water washing, hydrochloric acid, water washing, rust prevention, and electrophoresis in Thailand. Finally, the finished ball stud and ball housing are assembled together with the rest of the Chinese components in Thailand to produce a finished ball joint.
Section 304 of the Tariff Act of 1930, as amended (19 U.S.C. 1304), provides that unless excepted, every article of foreign origin imported into the United States shall be marked in a conspicuous place as legibly, indelibly, and permanently as the nature of the article (or its container) will permit, in such a manner as to indicate to the ultimate purchaser in the United States, the English name of the country of origin of the article.
Congressional intent in enacting 19 U.S.C. 1304 was “that the ultimate purchaser should be able to know by an inspection of the marking on the imported goods the country of which the goods is the product. The evident purpose is to mark the goods so that at the time of purchase the ultimate purchaser may, by knowing where the goods were produced, be able to buy or refuse to buy them, if such marking should influence his will.” See United States v. Friedlander & Co., 27 C.C.P.A. 297, 302 (1940).
Part 134 of the U.S. Customs and Border Protection (“CBP”) Regulations (19 CFR 134) implements the country of origin marking requirements and exceptions of 19 U.S.C. 1304.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N347758).