The eligibility of the United States-Mexico-Canada Agreement (USMCA) of a Multi-bit Ratcheting Screwdriver from Canada
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Ruling text
In your letter dated April 16, 2025, you requested a binding ruling on the eligibility of a Multi-Bit Ratcheting Screwdriver under the United States-Mexico-Canada Agreement (USMCA). The merchandise is identified as a Megapro Multi-bit Ratcheting Screwdriver, item# 211R2C36RD. The screwdriver features a “pull-out” bit storage area within the ratcheting handle that holds six double ended screwdriver bits, i.e., Phillips 0-3, Phillips 1-2, Flat (slotted) 4-6, Torx 10-15, Torx 20-25 and Square (Robertson) 1-2.
You have stated that the tool is assembled in Canada with originating materials from Canada and non-originating materials from Taiwan and China. The metal ratchet assembly is manufactured in China and the screwdriver bits are manufactured in Taiwan. The balance of the components that comprise the finished screwdriver originate from Canada, including the injected molded plastic parts that make up the handle of the screwdriver.
The Chinese ratchet assembly and the Taiwanese bits are imported into Canada, where they are assembled with the plastic Canadian parts that comprise the handle. The fully assembled screwdriver is then exported to the United States, where is it packaged for retail sale. The USMCA was signed by the Governments of the United States, Mexico, and Canada on November 30, 2018.
The USMCA was approved by the U.S. Congress with the enactment on January 29, 2020, of the USMCA Implementation Act, Pub. L. 116-113, 134 Stat. 11, 14 (19 U.S.C. § 4511(a)). General Note (GN) 11 of the HTSUS implements the USMCA. GN 11(b) sets forth the criteria for determining whether a good is an originating good for purposes of the USMCA.
GN 11(b) states: For the purposes of this note, a good imported into the customs territory of the United States from the territory of a USMCA country, as defined in subdivision (l) of this note, is eligible for the preferential tariff treatment provided for in the applicable subheading and quantitative limitations set forth in the tariff schedule as a “good originating in the territory of a USMCA country” only if- (i) the good is a good wholly obtained or produced entirely in the territory of one or more USMCA countries; (ii) the good is a good produced entirely in the territory of one or more USMCA countries, exclusively from originating materials; (iii) the good is a good produced entirely in the territory of one or more USMCA countries using non-originating materials, if the good satisfies all applicable requirements set forth in this note (including the provisions of subdivision (o)); Since the Megapro Multi-bit Ratcheting Screwdriver contains non-originating components, it is not considered a good wholly obtained or produced entirely in a USMCA country under GN 11(b)(i), nor are the products produced exclusively from originating materials per GN 11(b)(ii).
Thus, we must determine whether the product qualifies under GN 11(b)(iii).
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N347917).