The country of origin of a commercial food warmer
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Key passages, quoted from the ruling
- Thus, based on the totality of the circumstances, the country of origin of the electric countertop food warmer, model number ENFW1204K, will be China.
Ruling text
In your letter dated April 22, 2025, you requested a country of origin ruling. The merchandise under consideration is described as an electric commercial countertop food warmer, model number ENFW1204K, that uses a hot water bath to cook and/or keep food warm. It has an open-top stainless-steel water well and dual heating elements to continuously heat water up to 172 degrees Fahrenheit. The water well can hold a 12-inch by 20-inch pan with a capacity up to 27 quarts.
An adjustable knob on the front of the unit controls the temperature. The food warmer is produced in Vietnam using components and materials sourced from China and Vietnam. The process begins with creating structural components, identified as an outer box, rear cover, heating rod cover plate, and bottom cover plate.
The outline of the rear cover, heating rod cover plate, and bottom cover plate are laser cut from galvanized steel sheets, then moved to a press where louvers, holes, and other openings are stamped into each piece by a worker. The same process is used to create the outer box which forms the front and sides of the unit but adds an extra step where a press brake bends the sheet into a three-sided shell. All the remaining components are sourced from China in a ready-to-assemble condition.
These include all the electrical components (i.e., a thermostat, a power cord, electric heating tubes, and indicator lights), the stainless-steel well (also referred to as the sink), plastic feet, and miscellaneous hardware, including nuts, bolts, screws, and washers. The first step in the assembly process is creating the outer enclosure and entails attaching the rear cover panel to the outer box using screws. Next, a worker installs the power light indicator, thermostat, front knob, and power cord.
Afterwards, the heating tubes are mounted onto the heating rod cover plate which is then attached to the bottom of the stainless-steel sink. The sink is mounted inside the enclosure and connected to the thermostat, indicator light, electric heating tubing, and power cord. Lastly, the circuit is inspected, a high voltage resistance test is conducted, and a power-on test is performed.
When determining the country of origin for purposes of applying current trade remedies under Section 301, and any additional duties, the substantial transformation analysis is applicable. See, e.g., Headquarters Ruling Letter H301619, dated November 6, 2018. The test for determining whether a substantial transformation will occur is whether an article emerges from a process with a new name, character, or use different from that possessed by the article prior to processing.
See Texas Instruments Inc. v. United States, 681 F.2d 778 (C.C.P.A. 1982). This determination is based on the totality of the evidence. See National Hand Tool Corp. v. United States, 16 C.I.T. 308 (1992), aff?d, 989 F.2d 1201 (Fed. Cir. 1993). CBP has held that whether an assembly process is sufficiently complex to rise to the level of a substantial transformation is determined upon consideration of all the operations that occur within that country.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N348083).