The country of origin of coil springs
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Ruling text
In your letter dated April 28, 2025, you requested a country of origin ruling on coil springs. Technical information was submitted with your The items under consideration are described as coil springs for use in automotive suspensions. In your letter, you state that coil springs control and relieve vibration, noise, and the impact transmitted into an automotive vehicle while driving.
In addition, coil springs maintain the movement of the tire which positively affects the condition of the automotive suspension and thus the vehicle. The subject coils springs are mainly composed of grade SAE 9254 silicon-chromium spring steel and will be imported in different sizes. Manufacturing of the coil springs begins in Korea with steel rod as the primary raw material. The rod undergoes cold processing operations which includes straightening, shot blasting, shearing, and polishing.
At this point, the rod goes through eddy current and ultrasonic testing. In some cases, the rod also undergoes centerless grinding prior to packing and shipment for export from Korea. The steel rod is shipped to the United States in diameters of 16.45 millimeters (mm) to 19.3 mm and in lengths of 1865 mm to 2815 mm. In the United States, the imported steel rod is heated in a furnace up to 980 degrees Celsius which causes physical changes in the steel and makes it malleable.
Once heated, the steel rod is coiled around a mandrel according to a specified shape. Following that, the formed coil spring is cooled down rapidly by quenching in a tank to increase the mechanical properties of the steel. Then, the quenched coil spring is reheated at constant temperature to increase strength. At this point the coil springs undergo hot setting, shot peening for surface quality, and cold setting.
The coil springs are then pretreated with a phosphate coating for corrosion resistance and to improve paint adherence. Finally, the coil springs are painted for surface integrity and tested under loads.
Section 304 of the Tariff Act of 1930, as amended (19 U.S.C. 1304), provides that unless excepted, every article of foreign origin imported into the United States shall be marked in a conspicuous place as legibly, indelibly, and permanently as the nature of the article (or its container) will permit, in such a manner as to indicate to the ultimate purchaser in the United States, the English name of the country of origin of the article.
Congressional intent in enacting 19 U.S.C. 1304 was “that the ultimate purchaser should be able to know by an inspection of the marking on the imported goods the country of which the goods is the product. The evident purpose is to mark the goods so that at the time of purchase the ultimate purchaser may, by knowing where the goods were produced, be able to buy or refuse to buy them, if such marking should influence his will.” See United States v. Friedlander & Co., 27 C.C.P.A. 297, 302 (1940).
Part 134 of the U.S. Customs and Border Protection (“CBP”) Regulations (19 C.F.R. 134) implements the country of origin marking requirements and exceptions of 19 U.S.C. 1304. Section 134.1(b), CBP Regulations (19 C.F.R.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N348322).