The tariff classification of wood boards from Brazil
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Key passages, quoted from the ruling
- The applicable subheading for the four-foot and six-foot dog-eared fence pickets will be 4421.90.7040, Harmonized Tariff Schedule of the United States (HTSUS), which provides for Other articles of wood: Other: Other: Pickets, palings, posts and rails, the foregoing which are sawn; assembled fence sections: Other.
Ruling text
In your letter, dated May 7, 2025, you requested a binding tariff classification ruling for wood boards. Product information was submitted for our review. The items under consideration are rough-sawn boards that are dog-eared at one end. The top two corners of each board are cut at a 45-degree angle. The boards are constructed of taeda pine (Pinus taeda) or Elliotis pine (Pinus elliotii). The boards measure approximately 5.5” wide by 0.6” thick by four feet, six feet, or eight feet in length.
You indicate that the boards are not treated with any preservatives, and are not finger-jointed or otherwise worked. You also state that the boards are not planed, sanded, finished, or otherwise worked. Six-foot-long and four-foot-long dog-eared boards are standard pickets within the U.S. fence industry. Customs has consistently classified these boards as pickets.
Customs has also consistently determined that boards exceeding six feet in length are not standard pickets and therefore are classifiable as wood sawn lengthwise of heading 4407. The applicable subheading for the four-foot and six-foot dog-eared fence pickets will be 4421.90.7040, Harmonized Tariff Schedule of the United States (HTSUS), which provides for Other articles of wood: Other: Other: Pickets, palings, posts and rails, the foregoing which are sawn; assembled fence sections: Other.
The rate of duty will be free.
The applicable subheading for the rough 8-foot taeda pine and Elliotis pine dog-eared boards will be 4407.11.0046, HTSUS, which provides for Wood sawn or chipped lengthwise, sliced or peeled, whether or not planed, sanded or end-jointed, of a thickness exceeding 6 mm: Coniferous: Of pine (Pinus spp.): Southern yellow pine (Loblolly pine (Pinus taeda)), long leaf pine (Pinus palustris), pitch pine (Pinus rigida), short leaf pine (Pinus echinata), slash pine (Pinus elliottii) and Virginia pine (Pinus virginiana): Rough.
The rate of duty will be free. Effective April 5, 2025, Executive Orders implemented ?Reciprocal Tariffs. All imported merchandise must be reported with either the Chapter 99 provision under which the reciprocal tariff applies or one of the Chapter 99 provisions covering exceptions to the reciprocal tariffs. At this time products from all countries will be subject to an additional 10 percent ad valorem rate of duty.
At the time of entry, you must report the Chapter 99 heading applicable to your product classification, i.e. 9903.01.25, in addition to subheading 4421.90.7040, HTSUS, listed above. The eight-foot boards fall within an excepted subheading. The eight-foot boards should be entered with the exclusion subheading 9903.01.32. Duty rates are provided for your convenience and are subject to change. The text of the most recent HTSUS and the accompanying duty rates are provided at https://hts.usitc.gov/.
The holding set forth above applies only to the specific factual situation and merchandise description as identified in the ruling request. This position is clearly set forth in Title 19, Code of Federal Regulations (CFR), Section 177.9(b)(1).
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N348722).