The country of origin of heat pump units
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Ruling text
In your letter dated May 12, 2025, you requested a country of origin ruling on heat pump units. Descriptive information was provided in the submission. The products at issue are heat pump units, part numbers 29.0218.41.0001 and 29.0218.41.0002. The rooftop heat pump units are referred to as air-conditioning units and are intended to be installed on the roof of recreational vehicles, caravans, pop-top caravans and camper trailers.
The units, which are powered using an alternating current power supply, are designed to change the temperature and humidity levels within a vehicle while stationary. The heat pumps consist of a shroud cover and a bottom plate assembly that enclose a compressor, an evaporator, a condenser, and other components that contribute to the cooling process. With respect to origin, you describe three origin scenarios for the heat pump units.
For scenarios one and two, the final assembly occurs in China, and for scenario three, the final assembly occurs in India. Prior to the final assembly, the compressor is assembled in India in scenario one and is assembled in China for scenarios two and three. The assembly of the compressor begins by casting the housing from aluminum or iron material, which is followed by the fabrication and machining of a crankshaft, a cylinder head and a piston.
These components, along with various other components, are used to construct subassemblies, such as a rotor and stator subassembly, a piston and cylinder subassembly and a motor-driven subassembly for electric compressors. Throughout these steps, lubrication is applied, and seals and valves are installed in the compressor housing. Afterwards, the compressor undergoes testing and a final inspection. Once the inspection is complete, the compressor undergoes a coating and is marked with a laser.
In the three scenarios, the evaporator and condenser are assembled in India prior to the final assembly. For the evaporator, tubes are cut to length using automatic tube cutters and subsequently bent into shape. Next, aluminum sheets are stamped into fins using die stamping machines. The tubes are then expanded inside the fin stack.
Afterwards, tubes and fins are assembled into a core using automated assembly lines or by manual stacking and then placed in a furnace to be heated to temperatures of approximately 600–700 degrees Celsius. Once the brazing process is complete, the remaining residues are removed using chemical cleaning, and the evaporator is subject to inspections and various testing.
After the inspections and testing are completed, the end connections and headers are installed, and the tube ends are flared and connected to the headers. Lastly, anti-corrosion coatings are applied. For the condenser, aluminum sheets are cut into sections, and the sectioned sheets are stamped using stamping machines to form thin, corrugated fins. Subsequently, copper tubes are cut and trimmed into the required lengths.
The tubes are then bent using tube benders, and the tubes and fins are assembled into the core of the coil. Once the brazing process is complete, the header is attached to the tube assembly and the end plates are welded in place.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N348913).