The country of origin of a Segway off-road vehicle
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Ruling text
In your letter dated May 13, 2025, you requested, on behalf of your client, Segway Powersports, Inc., located in McKinney, TX, a country of origin ruling on an off-road vehicle assembled in Thailand. The item under consideration has been identified as the Segway off-road vehicle (Segway), model # SGW1000F-U4. You identified over 600 parts that are shipped from China to Thailand and assembled into the finished vehicle. The main assembly line processes are highlighted below.
Install the Front Axle, rear stabilizer bar, panel, and heat shield Pre-assemble the steering gear (subassembly) ECU (engine control unit)/T-Box programming Install the floor panel and pre-install water pipes Pre-install the engine mounting brackets, and install the engine Pre-assemble exhaust elbow (subassembly) and install Install the drive shaft, air filter, throttle body, air ducts and engine exhaust pipe Install the velocity drive shaft, control arms, stabilizer bar ball joint, wheels and hub bearing housing Install the calipers, brake pipeline, shock absorbers, and steering tie-rods Pre-assemble the fuel tank (subassembly); pre-assemble front and rear seat brackets; pre-assemble the radiator (subassemblies); and then assemble to the vehicle Pre-assemble the front bumper (subassembly); install the parking brake lock and seat belt; install the seats and foot pedals Pre-assemble brake pedals (subassembly); fix wiring harness; assemble backrest support Install the muffler cylinder, reinforcement brace, crossbeam, shift lever, and relay Install the rectifier, winch relay, T-Box, steering column, connect pull lock and brake pipeline, and connect brake pedal and throttle Install the headlight covers, foot pedals, fuel filler, baffles, and tire covers Install the steering wheel Performance Test Pre-assemble the cargo box (subassembly) Install the vehicle exterior parts/accessories, including doors, storage box, armrest, floor panels, and headrests You provided documents that show that the Segway will go through thirty-three (33) workstations.
The entire assembly process takes thirty-four (34) workers approximately 15.55 hours per vehicle. When determining the country of origin for purposes of applying current trade remedies under Section 301 and additional duties, the substantial transformation analysis is applicable. See, e.g., Headquarters Ruling Letter H301619, dated November 6, 2018.
The test for determining whether a substantial transformation will occur is whether an article emerges from a process with a new name, character, or use different from that possessed by the article prior to processing. See Texas Instruments Inc. v. United States, 681 F.2d 778 (C.C.P.A. 1982). This determination is based on the totality of the evidence. See National Hand Tool Corp. v. United States, 16 C.I.T. 308 (1992), aff’d, 989 F.2d 1201 (Fed. Cir. 1993).
The substantial transformation test is fact-specific and applied on a case-by-case basis depending on the totality of factors. The primary focus of the substantial transformation test is whether the work or material added to an article in another country changed the character or use of the article.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N348937).