The country of origin of a gas-powered mini dirt bike
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Ruling text
In your letter dated May 14, 2025, you requested a country of origin ruling on behalf of your client, GoLabs, Inc., located in Carrollton, TX, for a mini dirt bike. You provided a video and documents showing the manufacturing process and a Bill of Material (BOM) showing the country of origin of all components and materials. The dirt bike, model B200R, is powered by a 196cc gas powered spark-ignition internal combustion engine.
The specific specifications for the B200R are the following: Single cylinder air-cooled 4-stroke Displacement: 196cc Rated Power: 4.85KW/3600rpm (6.5 hp) Max Torque: 9.76 ft-lbs/2500 rpm Weight: 34 lbs. Ignition System: Non-contact Transistorized Ignition (TCI) Start Mode: Recoil pull start Fuel Tank Capacity: 3.5 liters (0.93 gallons) You state all bike frame manufacturing and assembly occurs in Vietnam. The stamped tubular parts of the frame are fabricated and assembled by welding.
Once fully assembled, the bike frame assembly is exported to China for further processing. The following assembly steps occur in China: Frame Pre-Processing: The frame is positioned on the marking fixture and the VIN is printed. Anti-rust oil is then applied. Handlebar Sub-Assembly: The grip, headlight switch, and rear brake lever are installed on the left side. The kill switch is mounted. The throttle limiter bracket, throttle limiter inserts, throttle cable, and grip are installed on the right side.
Lower Triple Clamp Sub-Assembly: The left and right headlight brackets and front fender mounting plates are attached to the lower triple clamp. It is secured with flange bolts and nuts. Rear Wheel Sub-Assembly: Bearings, rear wheel hub spacers, and support washers are installed into the rear wheel. The sprocket is mounted, and the brake disc is secured. Front Wheel Sub-Assembly: Bearings, front wheel hub spacers, and support washers are installed into the front wheel.
Steering and Foot peg Assembly: Lubricant is applied to steering stem races. The front forks are mounted. The lower and upper triple clamps are installed. Front/Rear Fenders: The reflector, front fender, and rear fender are installed. Handlebar Assembly: The clutch is installed and connected to the idler sprocket. The handlebar is positioned and secured. Headlight and Throttle Cable Assembly: The main wiring harness is routed and secured. The headlight is attached. The regulator is installed.
The throttle cable is connected to the carburetor and adjusted. The chain guard is attached. Rear Disc Brake and Chain Cover Assembly: The chain cover is installed, the side stand is mounted, and the rear brake caliper is secured. The seat is fastened. The bike is stabilized on the shipping frame and packaged in a corrugated box for shipping. Additionally, the engine reduction bracket sub-assembly and engine and foot peg mounting occur in China.
When determining the country of origin, the substantial transformation analysis is applicable. See Headquarters Ruling Letter (“HQ”) H301619, dated November 6, 2018.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N349019).