The country of origin of a CV axle
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Ruling text
In your letter dated April 25, 2025, you requested a country of origin ruling on a CV axle for marking purposes. The article under consideration is a Constant Velocity (CV) Axle, Part Number TO-86006, which is used in passenger vehicles. The CV axle consists of a central shaft with inner and outer joints at each end, both of which are covered by flexible rubber boots to prevent the intrusion of external contaminants such as moisture, dirt, and debris.
These joints make it possible for the transmission to drive the front wheels smoothly and reliably, by permitting a range of motion through the use of bearings. In short, the CV axle makes angles and angle movement possible. The CV axle, also known as a half shaft, takes power from the vehicle's transmission and differential and transfers it to the wheels, allowing the vehicle to drive forward.
The CV axle consists of an outer ball joint (OBJ) housing, inner ball joint (IBJ) housing, center bar, inner race, cage, steel balls, anti-lock braking system (ABS) ring, circlips, dust rings, and clamps sourced from China and sent to Vietnam to be assembled together with the Vietnamese CV boots and tripod. The production process of the CV axle involves multiple stages of precision machining and assembly.
The initial stage is hard turning and hard milling for both the ball cage and inner race, which involves machining hardened materials while maintaining strict tolerances, using CNC hard turning lathes and highspeed hard milling machines. It is followed by a grinding step and ball track grinding of spherical surfaces of the inner housing and inner ring to ensure proper ball movement and overall CV axle performance, using profile grinding machines.
Finally, all components are assembled together ready for import into the United States.
Section 304 of the Tariff Act of 1930, as amended (19 U.S.C. 1304), provides that unless excepted, every article of foreign origin imported into the United States shall be marked in a conspicuous place as legibly, indelibly, and permanently as the nature of the article (or its container) will permit, in such a manner as to indicate to the ultimate purchaser in the United States, the English name of the country of origin of the article.
Congressional intent in enacting 19 U.S.C. 1304 was “that the ultimate purchaser should be able to know by an inspection of the marking on the imported goods the country of which the goods is the product. The evident purpose is to mark the goods so that at the time of purchase the ultimate purchaser may, by knowing where the goods were produced, be able to buy or refuse to buy them, if such marking should influence his will.” See United States v. Friedlander & Co., 27 C.C.P.A. 297, 302 (1940).
Part 134 of the U.S. Customs and Border Protection (“CBP”) Regulations (19 CFR 134) implements the country of origin marking requirements and exceptions of 19 U.S.C. 1304. Section 134.1(b), CBP Regulations (19 CFR 134.1(b)), defines “country of origin” as the country of manufacture, production, or growth of any article of foreign origin entering the United States.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N349382).