The country of origin of a fuel pump assembly
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Ruling text
In your letter dated May 31, 2025, you requested a country of origin ruling on behalf of Carter Fuel Systems. Descriptive information was provided with your submission. The fuel pump assembly is primarily comprised of a top cover and a bottom shell that encases an electric pump and an oil assembly. The fuel pump assembly, which is designed to be used in passenger vehicles, transports fuel from the fuel tank to the carburetor or fuel injectors.
With respect to origin, the final assembly of the fuel pump occurs in Thailand and consists of components sourced from Thailand and China. Prior to the final assembly of the pump, the rotor used in the fuel pump is produced in Thailand. This process begins by pressing a shaft from China into an iron core from China. The iron core is subsequently pressed into a sheath. Next, insulation paper is inserted into the armature, and the armature is then pressed into a Chinese sourced commutator.
Afterwards, processes such as winding, welding, and turning, are completed. Once the turning process is complete, the commutator is run through a slot, and spot welding is performed as deemed necessary. Throughout the steps, inspections and testing are completed. The fuel pump is also assembled in Thailand and commences with the assembly of a check valve using a riveting process. Once assembled, the valve is installed into the oil outlet nozzle of a Thai produced pump head.
Afterwards, a wire end brush is inserted at the hook, allowing the positive and negative inserts to be welded in place. The resulting assembly, along with a carbon brush spring from Thailand, are inserted into a carbon brush holder and press-fit in place. Next, the pump head assembly is pressed onto the carbon brush holder, a stator assembly is pressed into the pump head, and a rotor assembly is pressed into the bottom casing of the pump.
Afterwards, a Chinese produced impeller, along with lower and upper pump assemblies, which are sourced from Thailand, are inserted into the bottom casing, pressed into position and edge sealed. Inspections and testing are completed throughout the steps. The final assembly of the pump assembly begins by installing an O-ring and a socket into a top cover socket. Once the top cover is sealed, a valve assembly is pressed into the top cover and a steel ball and filter screen are pressed into a back cover.
Bellows sourced from China are then pressed into the pump cover nozzle and pneumatically clamped in place. Next, the rear cover of a pump bracket is pressed into the oil inlet of the pump, and a pump holder is installed into the head of a fuel pump, which is then pressed onto the pump bracket. Subsequently, three guide rods are installed into the holes of a top cover, and three support springs are pressed into the top cover holes.
Bellows sourced from China are then pressed into the top cover nozzle and pneumatically clamped in place. Afterwards, a diaphragm, which functions as the bottom shell, is aligned with an oil storage barrel. Then, an antivibration foot pad, a filter from China, and an oil level sensor assembly are installed.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N349662).