The country of origin of garden forks
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Ruling text
In your letter dated June 3, 2025, you requested a country of origin determination on two garden forks (SKU# 1152251 and SKU# 4412615) for purposes of Section 301 duties and marking under Section 304 of the Tariff Act of 1930, as amended (19 U.S.C. 1304). Pictures and descriptions of the manufacturing process were included in your submission. Both garden forks have steel heads with slightly bent tines that are attached to long handles.
SKU# 1152251 incorporates ten tines on its head and is attached to a fiberglass handle. SKU# 4412615 includes six tines on its head and is attached to a wooden handle. They are primarily designed for soil preparation, including loosening, lifting, and turning over soil, as well as aerating and mixing in compost. The manufacturing process for both forks is the same. You have stated that in Vietnam hot-rolled steel that originates in China is laser-cut into a flat outline of the heads of each fork.
The tines of the fork head are further heated and forged, and a handle connector is formed. The fork head is then press-bent into its final curved shape. The fully formed fork head is afterwards sent to China where it is polished, powder coated and assembled with a Chinese-origin wood or fiberglass handle. Finally, plastic grips are attached to the middle and end of the handle.
When determining the country of origin for purposes of applying current trade remedies under Section 301 and additional duties, the substantial transformation analysis is applicable. See, e.g., Headquarters Ruling Letter H301619, dated November 6, 2018. The test for determining whether a substantial transformation will occur is whether an article emerges from a process with a new name, character, or use different from that possessed by the article prior to processing.
See Texas Instruments Inc. v. United States, 681 F.2d 778 (C.C.P.A. 1982). This determination is based on the totality of the evidence. See National Hand Tool Corp. v. United States, 16 C.I.T. 308 (1992), aff’d, 989 F.2d 1201 (Fed. Cir. 1993).
Additionally, Section 304 of the Tariff Act of 1930, as amended (19 U.S.C. 1304), provides that unless excepted, every article of foreign origin imported into the United States shall be marked in a conspicuous place as legibly, indelibly, and permanently as the nature of the article (or its container) will permit, in such a manner as to indicate to the ultimate purchaser in the United States, the English name of the country of origin of the article.
Congressional intent in enacting 19 U.S.C. 1304 was “that the ultimate purchaser should be able to know by an inspection of the marking on the imported goods the country of which the goods is the product. The evident purpose is to mark the goods so that at the time of purchase the ultimate purchaser may, by knowing where the goods were produced, be able to buy or refuse to buy them, if such marking should influence his will.” See United States v. Friedlander & Co., 27 C.C.P.A. 297, 302 (1940).
Part 134 of the U.S. Customs and Border Protection (“CBP”) Regulations (19 CFR 134) implements the country of origin marking requirements and exceptions of 19 U.S.C. 1304.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N349746).