The country of origin of an audio amplifier
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Key passages, quoted from the ruling
- Therefore, since a substantial transformation does not occur as a result of the Chinese processing, the country of origin of the finished Harbinger VARI V3412 Audio Amplifier/Speaker will be Thailand for origin and marking purposes at time of importation into the United States.
Ruling text
In your letter dated June 5, 2025, you requested a country of origin ruling on an audio amplifier/speaker on behalf of your client, Guitar Center, Inc. The item concerned is an audio amplifier (Harbinger VARI V3412 Audio Amplifier/Speaker). This device is a portable sound system with advanced electronic features for amplification and sound reproduction of instruments and voice. It includes a pre-amp and sound mixer that supports up to five simultaneous input sources.
The subject amplifier consists primarily of a back panel (chassis) that houses a variety of printed circuit board assemblies (PCBAs) that are used to provide the amplification and electronic functionality of the product. The chassis assembly is combined with speakers and enclosed within an outer housing.
Manufacturing Process for the Harbinger VARI V3412 Amplifier: The back panel (chassis assembly), which houses the electronics needed to provide the amplification and all other electronic functionality, is manufactured within Thailand. The back panel incorporates various PCBAs, battery management components, knobs, and wire/cables.
All the PCBAs in the subject amplifier will be manufactured in Thailand: • Pre-AMP PCBA • IC, BT Module F-3020 • POWER PCBA • USB PCBA • LED PCBA The back panel chassis assembly is then sent to China. Within China, the back panel assembly will be connected to Chinese origin speakers and then encased within a China origin housing. When determining the country of origin for purposes of applying current trade remedies under Section 301 and additional duties, the substantial transformation analysis is applicable.
See, e.g., Headquarters Ruling Letter H301619, dated November 6, 2018. The test for determining whether a substantial transformation will occur is whether an article emerges from a process with a new name, character, or use different from that possessed by the article prior to processing. See Texas Instruments Inc. v. United States, 681 F.2d 778 (C.C.P.A. 1982). This determination is based on the totality of the evidence.
See National Hand Tool Corp. v. United States, 16 C.I.T. 308 (1992), aff’d, 989 F.2d 1201 (Fed. Cir. 1993).
Additionally, Section 304 of the Tariff Act of 1930, as amended (19 U.S.C. 1304), provides that unless excepted, every article of foreign origin imported into the United States shall be marked in a conspicuous place as legibly, indelibly, and permanently as the nature of the article (or its container) will permit, in such a manner as to indicate to the ultimate purchaser in the United States, the English name of the country of origin of the article.
Congressional intent in enacting 19 U.S.C. 1304 was “that the ultimate purchaser should be able to know by an inspection of the marking on the imported goods the country of which the goods is the product. The evident purpose is to mark the goods so that at the time of purchase the ultimate purchaser may, by knowing where the goods were produced, be able to buy or refuse to buy them, if such marking should influence his will.” See United States v. Friedlander & Co., 27 C.C.P.A. 297, 302 (1940). Part 134 of the U.S.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N349869).