The country of origin of a glucose monitoring device
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Ruling text
In your letter dated June 10, 2025, you requested a country of origin ruling on a glucose monitoring device. Descriptive literature was provided for our review. The item under consideration is described as the Atlas CGM Reader, which is a continuous glucose monitoring device for patients with diabetes mellitus. It is a compact, handheld device used in conjunction with Abbott’s FreeStyle Libre sensor to help people with diabetes monitor their glucose levels.
The CGM Reader receives data from a glucose sensor that is applied to the patient’s arm. It analyzes and transforms the data into meaningful glucose readings including directional trend arrows on a pre-defined time interval that provides the patient with a more complete glucose history than traditional blood glucose monitoring. The CGM Reader also provides glucose alarms for the detection of episodes of low glucose (hypoglycemia) and high glucose (hyperglycemia).
In regards to the origin of the Reader, all of the research and development, product engineering, hardware design, product software development, and other design investment for the CGM Reader occur in the United States.
In total, the CGM Reader is comprised of 228 parts, the majority of which make up the printed circuit board assembly. 41% of the parts by value are from China (including the liquid crystal display, battery, bare PCB, and vibration motor as the most expensive components); 10% from Taiwan (flash memory); 5% from Thailand (transceiver); 4% from Singapore (plastic components); 3% from Japan; 2% from Vietnam; 1% each for Philippines, Korea and Malaysia; and the remaining 32% (primarily capacitors, resistors, inductors, diodes and other electronic components) being dual-sourced from two or more of the above-mentioned countries.
The manufacturing of the CGM Reader occurs in six stations. Station 1 - Flash Memory Chip Programming: The first step may occur in either Singapore or Malaysia. This station loads the US-origin CGM Reader software onto the individual flash memory chips and verifies that it was correctly programmed. These flash memory chips are programmed “offline” at dedicated programming stations. The programmed flash memory chips are then sent to the next station for further processing.
Station 2 - PCBA Surface Mount Technology (SMT) Process: The SMT process occurs in Malaysia and begins with applying solder paste onto the bare PCB. Programmed flash memory chips from Station 1 and other electronic components, such as resistors, capacitors, and integrated circuits, are then placed onto the solder paste. The solder, which melts and solidifies in a high-temperature reflow oven, creates strong electrical and mechanical bonds between the components and the PCB.
These components are connected to the PCB through the solder and to each other through copper traces within the PCB. Station 3 - PCBA Programming and Functional Testing: This programming station also occurs in Malaysia and loads a US-origin CGM Reader application, which is part of the software package, into the flash memory chip on the PCBA and verifies correct programming.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N350041).