The country of origin and marking of a mode shift actuator for top-loading washing machines
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Ruling text
In your letter dated June 16, 2025, on behalf of your client HTI Technology & Industries, Inc. (HTI), you requested a ruling on country of origin and marking. The product in question is a Mode Shift Actuator, part number 219000, which will be produced in China and Cambodia using components of these and other countries under two different production scenarios.
Its role is to enable the transition between the top-loading washing machine’s agitating wash cycle and the spin/dry cycle by mechanically engaging or disengaging the agitator clutch. You state that at the end of the wash cycle, the washing machine’s controller activates the Mode Shift Actuator’s gear motor, which lifts the agitator clutch gear. This disengages the agitator from the agitator/drum motor, allowing the tub to spin freely during the spin/dry cycle to drain water from the tub.
After the spin cycle, the Mode Shift Actuator’s gear motor is reactivated to lower the clutch back into place, re-engaging the agitator/drum motor with the agitator, and readying the machine for the next wash cycle. The Mode Shift Actuator includes a cam, mounted on the motor shaft and designed with an axial ramp profile, which interacts with a spring-loaded pivoting component referred to as the yoke.
As the gear motor rotates, the yoke tracks the contour of the cam, translating the rotational motion into linear displacement of the clutch. The Mode Shift Actuator also uses a microswitch to provide electrical feedback confirming the clutch position. In production scenario 1, HTI will purchase the gear motor, microswitch, and Tyco terminal and housing from China. The plastic yoke, cam, and the bracket that holds these in place will be injection molded in Cambodia.
The remaining components, including lead wires, switch quick connect, torsion spring, clips, screws, and tape will be purchased from either Cambodia, Taiwan, or India. All assembly, testing, and packaging will take place in Cambodia. In production scenario 2, HTI will purchase the gear motor, microswitch, lead wires, switch quick connect and Tyco terminal and housing from China. The yoke, cam, and bracket will be injection molded in Cambodia.
The remaining components will be purchased from one of the non-China countries indicated in scenario one. As in scenario 1, all assembly, testing and packaging will take place in Cambodia. For both production scenarios, the Cambodian assembly operations include: 1) automated crimping or swaging of wires, leads, and connectors; 2) using automated equipment to screw the motor onto the bracket; 3) automated taping of the wire harness, and 4) aligning, pressing, and fitting together of the main components.
When determining the country of origin, the substantial transformation analysis is applicable. See, e.g., Headquarters Ruling Letter H301619, dated November 6, 2018. The test for determining whether a substantial transformation will occur is whether an article emerges from a process with a new name, character, or use different from that possessed by the article prior to processing. See Texas Instruments Inc. v. United States, 681 F.2d 778 (C.C.P.A. 1982).
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N350285).