The country of origin and marking of battery chargers
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Key passages, quoted from the ruling
- Based upon the facts presented, the country of origin for marking and trade remedy purposes, for the battery chargers, model numbers IC, ICL, RC, RQ, and XV, will be Indonesia.
Ruling text
In your letter dated June 18, 2025, you requested a country of origin ruling on behalf of your client, Delta-Q Technologies Corporation. There are five versions of what is described as a battery charger at issue with this request. The versions are identified by model numbers IC, ICL, RC, RQ, and XV. The subject chargers are used in a variety of industrial and recreational machinery, such as electric pallet jacks, scissor lifts, golf carts, and e-mobility scooters.
The charger consists of a printed circuit board assembly (PCBA) within a cast enclosure and incorporates various electrical connectors. You state that the primary difference between the models is the size of the PCBA, which is dependent upon the voltage rating needed by the end customer. In your request, you note that the manufacturing process for all five models is substantially similar and only differs slightly.
This begins in Indonesia with the creation of the PCBA by adding the various electrical components, including integrated circuits, resistors, transistors, capacitors and others, through a soldering, through-hole, and surface mount technology (SMT) process to the bare printed circuit board. This finished PCBA is then tested for functionality and sent to China where it is glued within the cast enclosure.
The connectors are then added before the lid is attached and the finished device is tested and packaged for shipment to the United States. When determining the country of origin for purposes of applying current trade remedies under Section 301 and additional duties, the substantial transformation analysis is applicable. See, e.g., Headquarters Ruling Letter H301619, dated November 6, 2018.
The test for determining whether a substantial transformation will occur is whether an article emerges from a process with a new name, character, or use different from that possessed by the article prior to processing. See Texas Instruments Inc. v. United States, 681 F.2d 778 (C.C.P.A. 1982). This determination is based on the totality of the evidence. See National Hand Tool Corp. v. United States, 16 C.I.T. 308 (1992), aff’d, 989 F.2d 1201 (Fed. Cir. 1993).
Additionally, Section 304 of the Tariff Act of 1930, as amended (19 U.S.C. 1304), provides that unless excepted, every article of foreign origin imported into the United States shall be marked in a conspicuous place as legibly, indelibly, and permanently as the nature of the article (or its container) will permit, in such a manner as to indicate to the ultimate purchaser in the United States, the English name of the country of origin of the article.
Congressional intent in enacting 19 U.S.C. 1304 was “that the ultimate purchaser should be able to know by an inspection of the marking on the imported goods the country of which the goods is the product. The evident purpose is to mark the goods so that at the time of purchase the ultimate purchaser may, by knowing where the goods were produced, be able to buy or refuse to buy them, if such marking should influence his will.” See United States v. Friedlander & Co., 27 C.C.P.A. 297, 302 (1940). Part 134 of the U.S.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N350383).