The country of origin of a microwave hood combination
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Ruling text
In your letter dated June 20, 2025, on behalf of your client Whirlpool Corporation, you requested a country of origin determination ruling for a microwave hood combination for the purposes of applying current trade remedies under Section 301. The microwave hood combination is an electric kitchen appliance that combines the functions of a microwave oven and a range hood (also known as a vent hood) into a single unit.
It is typically installed above the cooktop and combines the convenience of microwave cooking with the ventilation necessary for removing smoke, steam, and odors from the cooking process. The microwave hood combination consists of the following key assemblies or components: a bottom plate assembly, printed circuit board assembly (PCBA), high voltage (HV) transformer, magnetron, control panel assembly, door assembly, cavity, and an outer wrapper assembly.
You summarize the significant steps for producing the microwave hood combinations as the following: Manufacture of Outer Wrapper Assembly The production of the outer wrapper assembly occurs in Mexico. Production of the outer wrapper begins with cutting blank sheet steel to the required size.
The cut portions are then stamped in four steps: (1) deep draw; (2) punching and bending; (3) creating a 45-degree flange on a portion of the outer wrapper; and (4) pressing certain portions of the wrapper so that they are flat. This work, which incorporates four stamping dies, is performed while the material proceeds through the stamping machine line. After these steps, rivets are inserted into the outer wrapper assembly using a riveting machine.
Next, using a bending machine, the outer wrapper is bent from a generally flat shape (as stamped) to a “U-shape” to take the basic shape of three sides of the microwave oven.
Finally, the assembly proceeds to the painting production line, where powder coating in the desired color is applied to the surface in four steps: (1) pre-degreasing; (2) degreasing; (3) rinsing; (4) applying a protective nano-ceramic coating to the wrapper; (5) re-rinsing; (6) drying; (7) cooling; (8) applying the powder coating; (9) curing; and (10) final cooling. Once these steps are complete, the outer wrapper is ready for installation during the microwave assembly process.
Manufacture of Bottom Plate Assembly The production of the bottom plate assembly occurs in Mexico. Similar to the outer wrapper assembly, producing the bottom plate assembly begins with cutting blank sheet steel to size. The cut pieces are then stamped in five steps: (1) deep draw; (2) cutting and bending; (3) additional cutting and bending; (4) creating a flange on a portion of the outer wrapper; and (5) pressing the bottom plate assembly flat.
Finally, the bottom plate assembly is powder coated using the same 10 steps described above in connection with the outer wrapper assembly. Manufacture of Door Assembly, Including Door Glass The production of the door assembly occurs in Mexico. The door glass is made in Mexico. The remaining door assembly components are made in China.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N350470).