The country of origin and marking of photovoltaic junction boxes
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Key passages, quoted from the ruling
- The country of origin for marking and trade remedy purposes of the jbox assemblies, part numbers PV-JB03D and PV-JB12x, will be Malaysia or Thailand, where the harness originates.
Ruling text
In your letter dated June 24, 2025, you requested a country of origin ruling. There are two items at issue with this request, which are each described as photovoltaic junction box assemblies, or jboxes. The first jbox is identified by part number PV-JB03D. The fist jbox is comprised of a plastic housing within which are electrical terminals and an optional semiconductor diode.
Attached to the terminals are two insulated electrical conductors, one with a positive polarity and one with a negative polarity, that extend from the housing. At the end of each conductor are specific electrical connectors designed to be attached to a solar panel after importation. The second jbox is identified by part number PV-JB12x and is comprised of three plastic housings that contain electrical terminals and optional semiconductor diodes.
Two insulated electrical wire harnesses extend from the housings, one with a positive polarity and one with a negative polarity. At each end of the harness are electrical connectors designed to be attached to a solar panel after importation. In use, both jbox assemblies function identically. The subject devices are specifically used as a subcomponent in solar panel assemblies in order to supply the generated electricity from the panel to the outside source.
The diode, if present, acts to prevent the backflow of electricity into the panel that could create an electrical failure. In your request, you state that the assembly process for the subject jboxes is substantially similar. Insulated, complete wire harnesses are manufactured in Thailand or Malaysia and shipped on reels to China. In China, the cables are cut to length and the ends are stripped prior to the connectors being attached.
The diodes are then placed into the plastic housings before the harnesses are welded onto the terminals within the housing. The housing is then closed and the completed device is tested and packaged for shipment to the United States. When determining the country of origin for purposes of applying current trade remedies under Section 301 and additional duties, the substantial transformation analysis is applicable. See, e.g., Headquarters Ruling Letter H301619, dated November 6, 2018.
The test for determining whether a substantial transformation will occur is whether an article emerges from a process with a new name, character, or use different from that possessed by the article prior to processing. See Texas Instruments Inc. v. United States, 681 F.2d 778 (C.C.P.A. 1982). This determination is based on the totality of the evidence. See National Hand Tool Corp. v. United States, 16 C.I.T. 308 (1992), aff’d, 989 F.2d 1201 (Fed. Cir. 1993).
Additionally, Section 304 of the Tariff Act of 1930, as amended (19 U.S.C. 1304), provides that unless excepted, every article of foreign origin imported into the United States shall be marked in a conspicuous place as legibly, indelibly, and permanently as the nature of the article (or its container) will permit, in such a manner as to indicate to the ultimate purchaser in the United States, the English name of the country of origin of the article. Congressional intent in enacting 19 U.S.C.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N350562).