The country of origin of an electronic pneumatic lumbar support system
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Key passages, quoted from the ruling
- Therefore, the country of origin of the 7CELL will be South Korea, China Section 301 remedies do not apply.
Ruling text
In your letter dated June 25, 2025, you requested a country of origin ruling on an electronic pneumatic lumbar support system on behalf of your client, Leggett & Platt Automotive (Korea) LLC. (LPA Korea) The merchandise under consideration is referred to as the “JK1 PE 7CELL Electronic Pneumatic Lumbar Support System (7CELL). You state that the 7CELL is a vehicle seat subassembly, which will be integrated into and fully enclosed in vehicle seats to be installed in certain passenger vehicle models and trims.
Positioned inside the lower (lumbar) portion of the vehicle seat’s backrest, the 7CELL will be permanently attached to the seat frame with fasteners, connected via the 7CELL’s air pump cable to a vehicle power source, and wired via its Electronic Control Unit (ECU) wire to an exterior touch panel accessible to the seat occupant.
You present the following manufacturing process scenario, in which the plant in south Korea uses the South Korean-origin components and the Chinese-origin components to manufacture the 7CELLs in South Korea. By value, approximately 70% of the 7CELL’s components is sourced from and manufactured by suppliers located in Korea.
The components imported from China are: air pump fitted with an electric motor, spring loaded air tube and coated wire for connection to a power source, PET (polyurethane) cut-to-size air cells or bladders, plastic air tubes, copper solenoid valves with matching plastic seals for incorporation into the ECU, and several plastic clips to be used when the 7CELL is installed at the U.S. vehicle seat OEMs.
The plant(s) in South Korean will make the following components, then combines the components imported from China to make the finished 7CELLs.
You described the assembly process in South Korea as follows: ECU manufacture and programming Upon receipt of the specifications and input to produce and program ECUs to be used in vehicle model-specific 7CELL units, the plant uses surface mount technology (SMT) to position a microcontroller, transceiver, and other components onto a bare printed circuit board (PCB), loads the vehicle specific firmware onto the microcontroller, adds the eight copper solenoid valves and rubber seals to the PCB, and uses a plastic container to encase the PCB assembly.
Using a barcode on each PCB, the ECUs are tracked, labeled and packaged according to the vehicle model and trim for which they are intended. Wire suspension frame manufacture The wire suspension frame is designed to soften the feel of the 7CELL against the occupant’s back.
Raw uncut wire and coated wire–both manufactured in South Korea from South Korean steel–are fed into a wire bending machine that is programmed by LPA Korea to cut and bend the coated wires into two vertical supports and to cut, bend-tie horizontal “cross” wires onto the two vertical wires. Component assembly The 7CELL assembly process includes both manual and semi-automated sub-processes–soundproofing, tubing, and fastening–all of which are performed at LPA Korea’s Busan plant.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N350620).