The eligibility under the United States-Mexico-Canada Agreement (USMCA) of oven latch assemblies from Mexico and China
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Key passages, quoted from the ruling
- The oven latch assemblies, in manufacturing scenarios 1, 2 and 4 described above, qualify for USMCA upon compliance with all applicable laws, regulations, and agreements.
Ruling text
In your letter dated July 8, 2025, you requested a binding ruling on the eligibility of oven latch assemblies under the United States-Mexico-Canada Agreement (USMCA). The oven latch assemblies are identified as parts 311D6081P001 and 191D7106P007.
The oven latch assemblies each consist of nine components as below listed: Latch Pin Rod Power driver containing an electric motor Screw Metal bracket 1 Metal bracket 2 Metal bracket 3 Metal bracket 4 FACTS: You indicated in your submission that these latch assemblies are parts of gas-electric ranges for domestic use.
The gas-electric ranges are classified in subheading 8516.60.4082, Harmonized Tariff Schedule of the United States (HTSUS), which provides for cooking stoves, ranges and ovens, other, of a maximum width exceeding 70 centimeters: containing a radiant heated cooktop. The subject latch assemblies are classified in subheading 8516.90.8050, HTSUS, as parts for the cooking stoves, ranges and ovens of subheading 8516.60.40: other, other.
In your request, you present four manufacturing scenarios, in which the oven latch assemblies are fabricated with components of both Chinese-origin and Mexican-origin. In Scenarios 1, 2 and 4, the factory in Mexico will produce certain components from China and assemble them with the Mexican-origin components to make the finished oven latch assemblies.
In Scenario 3, the Mexican-origin component will be shipped to China and the factory in China will assemble the Mexican-origin component with the Chinese-origin components to make the finished products. In Scenario 1, all components are made in Mexico except for the pin, rod, and power driver, which are imported from China. In Scenario 2, all components are imported from China except for the power driver, which is produced in Mexico.
Scenario 3 is the same as Scenario 2 except that the final assembly will be in China instead of Mexico. Scenario 4 is the same as Scenario 1 except the power driver is made in Mexico and the screw is imported from China. USMCA: The USMCA was signed by the Governments of the United States, Mexico, and Canada on November 30, 2018. The USMCA was approved by the U.S. Congress with the enactment on January 29, 2020, of the USMCA Implementation Act, Pub. L. 116-113, 134 Stat. 11, 14 (19 U.S.C. § 4511(a)).
General Note ("GN") 11 of the HTSUS implements the USMCA. GN 11(b) sets forth the criteria for determining whether a good is an originating good for purposes of the USMCA.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N351075).