The country of origin of Outdoor Pedestrian Boundary Line LED work lamps
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Key passages, quoted from the ruling
- Therefore the country of origin of the finished Outdoor Pedestrian Boundary Line LED work lamps (models #s EW2025R and EW2025R-TOY) will be the Thailand.
Ruling text
In your letter dated July 8, 2025, you requested a country of origin ruling on two models of signaling lighting assemblies. The items concerned are referred to as Outdoor Pedestrian Boundary Line LED work lamps (models #s EW2025R and EW2025R-TOY). The EW2025R and EW2025R-TOY are rectangular LED work lamps designed for use outdoors to establish a safety zone around the perimeter of a vehicle or heavy equipment with a solid, colored beam of light.
This lighting safety zone acts as a signal which is intended to grab pedestrians’ attention. The EW2025R and EW2025R-TOY are virtually identical except for an additional connector on the EW2025R-TOY and different packaging and labeling. A complete description of the manufacturing process as well as the relevant bills of materials have been submitted with the request. The EW2025R and EW2025R-TOY are manufactured in both China and Thailand.
The singular printed circuit board assembly (PCBA) which contains all of the functional electrical components (LEDs, capacitors, resistors, diodes, etc.) and which provides the illumination is manufactured in Thailand using surface mount technology. The PCBA is then shipped to China where the final assembly occurs. The Chinese assembly process consists of assembling the lens, base, connector cable and PCBA into the finished goods. The base and connector cable are soldered to the PCBA.
The PCBA is secured into the housing by three screws. The PCBA and lens are glued and screwed into the housing. The finished goods (EW2025R and EW2025-TOY ) are then exported to the United States from China. When determining the country of origin, the substantial transformation analysis is applicable. See, e.g., Headquarters Ruling Letter (“HQ”) H301619, dated November 6, 2018.
The test for determining whether a substantial transformation will occur is whether an article emerges from a process with a new name, character, or use different from that possessed by the article prior to processing. See Texas Instruments Inc. v. United States, 681 F.2d 778 (C.C.P.A. 1982). This determination is based on the totality of the evidence. See National Hand Tool Corp. v. United States, 16 C.I.T. 308 (1992), aff’d, 989 F.2d 1201 (Fed. Cir. 1993).
Based upon the facts presented, it is the opinion of this office that the manufacturing processes that take place within Thailand to create the main PCBA is both substantial and complex. The character of this product is imparted by the PCBA which would be considered the dominant component of this assembly. The assembly/manufacturing process that takes place in China does not change the end use of the PCBA. The PCBA does not undergo a substantial transformation as a result of the Chinese processing.
Therefore the country of origin of the finished Outdoor Pedestrian Boundary Line LED work lamps (models #s EW2025R and EW2025R-TOY) will be the Thailand. The holding set forth above applies only to the specific factual situation and merchandise description as identified in the ruling request. This position is clearly set forth in Title 19, Code of Federal Regulations (CFR), Section 177.9(b)(1).
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N351122).