The country of origin of a first-generation wheel hub bearing
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Ruling text
In your letter dated May 16, 2025, on behalf of your client, APT Automotive Co., Ltd., you requested a country of origin ruling on a first generation wheel hub bearing to apply current trade remedies and for marking purposes. The article under consideration is referred to as a first-generation wheel hub bearing, part number 970613. The steel bearing consists of inner and outer races and two rows of caged balls.
Once pressed into a housing or a steering knuckle, the angular contact bearing minimizes friction within the suspension system of motor vehicles. With respect to origin, the final assembly occurs in Vietnam and consists of components sourced from China and Vietnam. Prior to the final assembly, the end faces and outside diameters of the Chinese sourced inner rings and the Vietnamese sourced outer rings undergo various grinding processes and superfinishing processes, converting the rings into races.
Throughout the grinding processes, the rings are turned, demagnetized, and heat-treated. During the final assembly, balls sourced from China are machine pressed into cages sourced from China and then pressed into inner and outer races. Afterwards, seals sourced from Vietnam are machined into the bearing and grease from Japan is incorporated into the bearing. Inspections are completed as required.
When determining the country of origin for purposes of applying current trade remedies and additional duties, the substantial transformation analysis is applicable. See, e.g., Headquarters (HQ) Ruling Letter H301619, dated November 6, 2018. The test for determining whether a substantial transformation will occur is whether an article emerges from a process with a new name, character, or use different from that possessed by the article prior to processing.
See Texas Instruments Inc. v. United States, 681 F.2d 778 (C.C.P.A. 1982). This determination is based on the totality of the evidence. See National Hand Tool Corp. v. United States, 16 C.I.T. 308 (1992), aff’d, 989 F.2d 1201 (Fed. Cir. 1993).
Additionally, Section 304 of the Tariff Act of 1930, as amended (19 U.S.C. 1304), provides that unless excepted, every article of foreign origin imported into the United States shall be marked in a conspicuous place as legibly, indelibly, and permanently as the nature of the article (or its container) will permit, in such a manner as to indicate to the ultimate purchaser in the United States, the English name of the country of origin of the article.
Congressional intent in enacting 19 U.S.C. 1304 was “that the ultimate purchaser should be able to know by an inspection of the marking on the imported goods the country of which the goods is the product. The evident purpose is to mark the goods so that at the time of purchase the ultimate purchaser may, by knowing where the goods were produced, be able to buy or refuse to buy them, if such marking should influence his will.” See United States v. Friedlander & Co., 27 C.C.P.A. 297, 302 (1940).
Part 134 of the U.S. Customs and Border Protection (CBP) Regulations (19 CFR 134) implements the country of origin marking requirements and exceptions of 19 U.S.C. 1304.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N351140).