The tariff classification of spray nozzles from Germany
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Ruling text
In your letter dated July 17, 2025, on behalf of your client, Greenleaf Technologies, Inc., you requested a tariff classification ruling. Descriptive literature was provided for our review. The items under consideration are described as Venturi-style spray nozzles, which are used for agricultural spray booms, and allow for a variety of spray range, pattern, and distribution. The nozzles are typically used for the application of pesticides, herbicides, and fertilizers.
The Venturi-style nozzles provide application to their target by using the Venturi-effect, a core principle of the nozzle that describes the pressure drop in a fluid as it flows through a constricted section of a pipe or nozzle. This pressure drop can then be used to draw in and mix a secondary fluid, such as air, into the primary stream. This process results in finer atomization and can improve spray coverage. The nozzles are completely passive and do not incorporate any mechanical features.
The first nozzle is the AM11004 - Nozzle AirMix Flat Fan, which is a 15mm by 22mm nozzle with a pressure of 14.5 pounds per square inch (PSI) to 87 PSI. This nozzle has a low-pressure flat fan venturi nozzle, two-piece design, and an air cleaning system. The droplet size is adjustable from coarse to fine through pressure, has a wide application range, and fits in double flat fan cap or ADF-caps.
The second nozzle is the TDXLV04 - Injector Standard Poly - Red, which is a 40mm by 38mm nozzle with a pressure of 14.5 PSI to 508 PSI. It has an injector with a cast standard bayonet and is a basic component of the TurboDrop modular system. The device is made of chemical-resistant plastic and has two side air intake openings. The third nozzle is the TDXL11004 TurboDrop Standard Poly, which is a 40mm by 50mm nozzle with a pressure of 14.5 PSI to 29 PSI.
The nozzle has a multi-range injector flat jet nozzle with a plastic design. It has a molded standard bayonet cap, variable, low-drift droplet spectrum, very large adjustable range, and is ideal for changing application rates and drop sizes. The fourth nozzle is the SMP8004 - Nozzle SprayMax, which is a 15mm by 11mm nozzle with a pressure of 14.5 PSI to 58 PSI. This nozzle is a standard flat jet nozzle with high precision. It has a large pressure and volume adjustment range as well as a high wear resistance.
The fifth nozzle is the CADF Cap for SprayMax, AirMix or BPDF Nozzles, which is a 32mm by 46mm by 38mm nozzle that has a pressure up to 145 PSI. It is suitable for nozzle holders with a standard bayonet system and can be combined with the TurboDrop injectors. The beam angle is 10 degrees in the front, 50 degrees in the rear, and has a short compact design. This device is narrower than comparable double flat jet caps and uses a slider system for easy assembly and cleaning.
While it is referred to as a “cap,” it essentially functions as a nozzle or contains nozzles within it that are responsible for the spray pattern and application.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N351451).