The classification, marking, and country of origin of two dryer vent cleaning kits from Vietnam.
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Ruling text
In your letter dated July 22, 2025, you requested a classification, marking, and country of origin ruling on behalf of your client, Great Star Tools. There are two products under consideration with both being dryer vent cleaning kits consisting of items from Vietnam and China. Your submission indicates that neither of these two cleaning kits are imported with drills, vacuums, or any parts, other than those listed below.
Further, all the parts within these kits are designed to work together to clean lint from dryer vents. The first kit consists of the following items: One 4-inch self-feeding auger brush with plastic bristles One 2.5-inch diameter lint brush with plastic bristles Two plastic 18-inch rods with threaded metal ends One hex key Two M4 screws The two brushes are made in Vietnam, and the other components are sourced from China.
The user may connect the rods together, if full length is needed, then attached the auger brush to the rod using the screws and hex key. The brush is then pushed into the dryer vent and turned either manually (by hand) or by attaching the rod to a drill. The auger brush is then pulled out of the dryer vent. The auger brush is removed from the rod and replaced with the lint brush. The lint brush is then pushed into the dryer vent and turned either manually or by attaching the rod to a drill.
These steps may be repeated until the user determines the vent is sufficiently clean.
The second kit consists of the following items: One 4-inch self-feeding auger brush with plastic bristles One 2.5-inch diameter lint brush with plastic bristles Four plastic 36-inch rods with threaded metal ends One round, plastic dryer adapter One round, plastic vacuum adapter One small, metal “C” shaped “blockage removal tool” One metal drill adapter One 5/16-inch hex nut One hex key Two M4 screws The two brushes are made in Vietnam, and the other components are sourced from China.
This set can clean longer vents than the first set but is used similarly. The auger brush is attached to one or more rods, and the drill adapter is attached to the other end of the rod(s) allowing it to be used with a drill. The auger brush is pushed through the vent while turning with the drill and then pulled out.
Optionally, when cleaning the vent from the inside of a house, the rod and auger brush are passed through the smaller of the two holes in the plastic vacuum adapter, while a vacuum hose is attached to the larger hole. This allows the adapter to form a seal with the vent hole in the wall so that the lint loosened by the spinning auger is suctioned into the vacuum while the cleaning is being performed. Then the auger brush is removed from the rod(s) and the lint brush is attached to perform the same cleaning steps.
This is repeated until the user determines the vent is sufficiently clean. We agree that both cleaning kits would be considered sets for classification purposes, and it would be the brush components of heading 9603 that impart the essential character to them, General Rule of Interpretation 3 (b) noted.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N351582).