The country of origin of fans
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Ruling text
In your letter dated July 29, 2025, you requested a country of origin ruling on behalf of your client, Jiangmen Lingfeng Electric Appliances Manufacturing Co., Ltd., to apply current trade remedies and for marking purposes. Information describing the assembly processes was submitted for review. The products at issue are a 20" Floor Fan (model number SFC1-500B), a 20" Shroud Fan (model number SFDE-500B3-1), a 16" Pedestal Fan (model number SFSR3-400CPT) and a 24" Drum Fan (model number SFDC2-600T).
Each fan is primarily comprised of a power cord, electrical components, a motor, and fan blades that are encased in protective front and rear grilles. Certain models feature casters and a pedestal that consists of a tube with a base. With respect to origin, the final assembly occurs in China and consists of components from China and Thailand. Prior to the final assembly, fan blades are manufactured in Thailand using cutting, stamping and shaping processes.
The motors used to power the four fan models are also assembled in Thailand using components sourced from Thailand. The remainder of the components are manufactured in China. To assemble the 20" shroud and floor fans, four interfaces of the switch are soldered to lead wire. An upper bracket is assembled to a spring, and lead wires are connected to a power cord, a motor and a capacitor. A motor switch flange and switch knob are then installed, and ground wires are connected.
Afterwards, a switch cover and an upper bracket are mounted to a motor, which is subsequently installed and screwed into a rear grille. A fan blade holder, a fan blade sleeve and fan blades are riveted to each other, and the fan blade assembly is then screwed onto the motor. Next, a shroud is secured to the rear grille, and finally, rubber legs are assembled to a bracket, and a front grille is joined to the shroud using screws. Once complete, tests and inspections are conducted.
For the 24" drum fan, four interfaces of the switch are soldered to lead wire. A motor is mounted on a rear grill and screwed in place. Next, a motor back plate is glued to a switch knob and rubber feet are screwed in place. Casters and a drum body are installed. The fan blade holder, a fan blade sleeve and fan blades are riveted to each other, and the fan blade assembly is screwed onto the motor. The front and rear grilles are mounted to a shroud and screwed in place.
Once complete, tests and inspections are conducted. For the 16" pedestal fan, a motor is screwed onto a front cover. Next, a fork cover, shaft sleeve and connecting rod are joined using screws. A switch is then assembled to wires, and the lead wire of the motor is connected to a power cord. A switch is mounted to a rear cover, a gearbox and a fork subassembly are screwed in place. The required knobs are screwed in place, and a front grille is mounted to a rear grille.
A fan blade holder, a fan blade sleeve and fan blades are riveted to each other. The fan blade assembly is screwed onto the motor, and the grilles are secured. Finally, an upper tube is installed and locked into the lower tube and then a base. Once complete, tests and inspections are conducted.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N351782).