The country of origin of fluid ends
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Ruling text
In your letter dated July 30, 2025, you requested a country of origin ruling on behalf of your client, Jereh Energy Equipment and Technologies Corporation, to apply current trade remedies and for marking purposes. The products at issue are standard fluid ends featured as three-cylinder and five-cylinder models. The fluid ends are a component of a piston pump used in hydraulic fracturing and in the oil and gas industry.
Once connected to a power end, the fluid ends pressurize fluid that is discharged through outlets. With respect to origin, two scenarios are described. In scenario one, rectangular shaped blocks are formed in China using a smelting, electroslag remelting and forging processes. The steel block forgings are then exported to South Korea to shape the outer surfaces and to drill cylinders.
The unfinished blocks are then heat treated, milled, and subjected to a boring process to meet the design and dimensions of a finished product, which functions as a housing for a fluid end. The final assembly, which also occurs in South Korea, involves various processes in which components primarily sourced from China are installed into a finished block. The assembly process begins by applying grease onto the sealing surface of various seals, which are afterwards installed into their respective grooves.
Next, various valves are inserted, which involves using tooling to press a valve insert into a valve body. Subsequently, discharge flanges, flange tees and O-rings are assembled to each other and then installed. Afterwards, various upper and lower valves are assembled, greased, and then inserted with springs, spring seats and spigots. Then, in sequence, packing sets, junk rings and spacer rings are installed and tightened in position, which is followed by the installation of plungers.
Finally, a flange and a flange tee are attached to the fluid end, and each finished fluid end is painted, tested and packaged. For scenario two, the smelting, electroslag remelting, forging and rough machining of the blocks are completed in South Korea. The final machining of the blocks and the assembly processes described above occur in China.
When determining the country of origin for purposes of applying current trade remedies under Section 301 and additional duties, the substantial transformation analysis is applicable. See, e.g., Headquarters Ruling Letter H301619, dated November 6, 2018. The test for determining whether a substantial transformation will occur is whether an article emerges from a process with a new name, character, or use different from that possessed by the article prior to processing.
See Texas Instruments Inc. v. United States, 681 F.2d 778 (C.C.P.A. 1982). This determination is based on the totality of the evidence. See National Hand Tool Corp. v. United States, 16 C.I.T. 308 (1992), aff’d, 989 F.2d 1201 (Fed. Cir. 1993). Additionally, Section 304 of the Tariff Act of 1930, as amended (19 U.S.C.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N351810).