The tariff classification of non-penetrating roof mounts from Canada
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Key passages, quoted from the ruling
- The applicable subheading for the non-penetrating roof mounts will be 7326.90.8688, HTSUS, which provides for Other articles of iron or steel: Other: Other: Other: Other: Other.
- The general rate of duty will be 2.9 percent ad valorem.
Ruling text
In your letter dated August 14, 2025, you requested a tariff classification ruling regarding non-penetrating roof mounts from Canada. Product information was submitted with your request. The items under consideration are three models of non-penetrating roof mounts (NPRMs) used to mount communication equipment such as antennas, radios, repeaters, and video surveillance equipment onto flat roofs. You state the roof mounts provide a transportable mounting option with no damaging roof penetration during installation.
The NPRMs consist of rigid, galvanized steel frames designed to be weighed down with cinder blocks or patio stones for stability. You state the NPRMs also contain aluminum components but confirm that steel predominates by a significant margin. In addition, the NPRMs feature mast supports to provide stability to an attached mast which extends vertically to hold communication equipment at a designated height above a roof surface.
In follow up correspondence, you confirmed there are no electronic or mechanical components included in the product at importation. Model NPRM-1/2-LD-5, labeled the “half base model,” features a rectangular frame measuring 48 inches in length by 30 inches in width. This model is designed to support an included mast which measures 2 inches in diameter and 60 inches in height. Within the base frame is a circular mast clamp in which the bottom of the mast sits.
When the mast is installed, three mast supports triangulate to support it along one side of the base. The half base model weighs 17 pounds when assembled. Models NPRM-2 and NPRM-3, labeled the “full base models,” feature square frames measuring 48 inches in length by 48 inches in width by 48 inches in height (including the mast supports). These models are designed to support a mast up to 2.5 inches in diameter and with a minimum height of 54 inches.
The full base models each feature four mast supports with top and base clamps or brackets to securely hold the mast in place. The base mast clamps or brackets are located in the center of the square base frame. The NPRM-2 and NPRM-3 models each weigh 45 pounds when assembled.
In your request, you suggest the NPRMs are classified in subheading 7308.20, Harmonized Tariff Schedule of the United States (HTSUS), which provides for Structures (excluding prefabricated buildings of heading 9406) and parts of structures (for example, bridges and bridge sections, lock gates, towers, lattice masts, roofs, roofing frameworks, doors and windows and their frames and thresholds for doors, shutters, balustrades, pillars and columns) of iron or steel; plates, rods, angles, shapes, sections, tubes and the like, prepared for use in structures, of iron or steel: Towers and lattice masts.
We disagree. We find that the NPRMs are not structures or parts of structures and are precluded from classification in heading 7308, HTSUS. Alternatively, you propose suggest classification in heading 9620, HTSUS. However, this merchandise is not similar to a tripod. Therefore, classification in heading 9620, HTSUS, is not applicable. Classification under the HTSUS is in accordance with the General Rules of Interpretation (GRIs).
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N352410).