The country of origin of an integrated circuit
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Key passages, quoted from the ruling
- Therefore, since a substantial transformation does not occur as a result of the back-end processing that takes place within the Philippines, the country of origin of the finished AZ33A Device will be the Taiwan for country of origin marking purposes.
Ruling text
In your letter dated August 18, 2025, you requested a country of origin ruling on a Wafer Level Chip Scale Packaged Product (WLCSP). The item concerned is an integrated circuit (IC) referred to as the AZ33A Device. This IC is a 24-bit delta-sigma Analog-to-Digital Converter (ADCs) that measures and reports analog input voltages. STAGE 1: FABRICATION PROCESS The fabrication process stage occurs in Singapore.
During the fabrication process, the wafer receives many of the components and characteristics of a WLCSP, but the subject item is not fully completed due to the omission of essential electrical circuitry.
Manufacturing steps undertaken in Singapore include: Manufacture of bare silicon wafer Epitaxial Growth Oxidation Thin-Film Deposition Lithography Dry etch by plasma Wet etch Ion Implantation Diffusion by furnace Chemical cleaning Metal Wiring Process/Metallization Wafer acceptance test After fabrication, the wafers are sent to Taiwan. STAGE 2: WLP FRONT-END In the WLP front-end process, a polymer layer encapsulates the wafer with select areas exposed.
A photo resist layer is applied to create the Redistribution Layer (“RDL”) line pattern where a copper plating is applied. Copper plating in the selected open area will form RDL metal line. The photo resist is then removed. A second polymer layer is applied to encapsulate the RDL lines as well as the exposed area on the wafer, only leaving a select area still exposed where RDL line needs to be connected to bump through UBM pad.
In the next process, called under bump metal (UBM), a layer of copper plating metal is applied in the exposed area to create a bonding pad for the solder ball. Finally, solder balls are placed onto UBM, and with a reflow solder ball will bond to UBM pad forming solder bump.
Manufacturing steps undertaken in Taiwan include: Polymer coating Annealing (Curing) Lithography Wet etch Copper metal deposition Copper metal plating Chemical clean Solder ball mounting Solder ball reflows Final Visual Inspection After the RDL layer application and the UBM, the completed WLCSP is formed. STAGE 3: WLP BACKEND The back-end process occurs in the Philippines. Here the completed WLCSP is evaluated, trimmed, mounted, and sawed to improve functionality.
However, the back-end process does not transform the WLCSP.
Manufacturing steps undertaken in the Philippines include: Wafer level testing Trim Wafer backside grinding (silicon thinning) Backside lamination (optional) Laser Marking Wafer mount and sawing Tape and reel Section 304 of the Tariff Act of 1930, as amended (19 U.S.C. 1304), provides that unless excepted, every article of foreign origin imported into the United States shall be marked in a conspicuous place as legibly, indelibly, and permanently as the nature of the article (or its container) will permit, in such a manner as to indicate to the ultimate purchaser in the United States, the English name of the country of origin of the article.
Congressional intent in enacting 19 U.S.C. 1304 was “that the ultimate purchaser should be able to know by an inspection of the marking on the imported goods the country of which the goods is the product.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N352561).