The country of origin of filter cartridges
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Ruling text
In your letter dated August 19, 2025, on behalf of your client, Membrane Platforms, LLC, you requested a country of origin ruling on filter cartridges. Descriptive literature was provided for our review. The items under consideration are described as filter cartridges, which are devices designed specifically for use in applications requiring hydrogen separation from hydrogen-based gas streams. The filter cartridges are intended to process gas mixtures from refineries, chemical, and petrochemical plants.
Each filter fits inside a module (housing) and multiple modules are used in a system installed at commercial plants. The gas separation filter works on the principle of selective permeation through the membrane fibers, which exploits the difference between the pressure of the gas on the retentate side (the interior of the hollow fibers) and the permeate side (the exterior of the hollow fibers).
The hollow membrane fibers are specially designed to withstand high differential pressures and allow certain gases to permeate the membrane walls while the remainder is collected at high pressure as the retentate stream. Membrane material and configuration are tailored to each application to achieve the optimum trade-off between purity and recovery for the target gas, in this case hydrogen. In the process, the filters remove impurities such as methane, carbon dioxide, argon, and nitrogen.
The membranes are comprised of manufactured small-diameter porous capillaries or hollow fibers. Hollow membrane fibers may be manufactured from a variety of industrial polymers (plastics) such as cellulose acetate, polysulfones, polyetherimide, and polyimides. The membranes subject to this ruling are made of polyimides, which is the polymer used for the gas separation membranes.
Each gas filtration cartridge is manufactured in the United Arab Emirates (UAE) from components from Russia, Germany, China, the U.S., and the UAE. The polymer fiber is produced in Russia while the bushing is made in Germany. The U.S. components include the amorphous fluoropolymer, heat-transfer and electronics-testing fluid, resin, epoxy, and curing agent. The Chinese components include the mandrel screen, cap screen and pot screen.
Finally, the UAE components include the machined mandrel, solid pot plug, cap end insert, and various O-rings. The first step in the manufacturing process includes setting up and tensioning of the fiber reels for winding around the filter mandrel followed by the assembly of the mandrel. Next, the winder is set up for proper winding around the mandrel (Interflow surface channel and flow distributor layer), which is critical to achieve the necessary separation according to specification for the specific application.
Next is the winding step, which involves the programming and helical winding of the fiber around the mandrel before drying and heat treating. Next, the terminal ends are hot wire cut, and the flow distribution screen is installed. The fiber ends are then sealed and epoxied before machining of the permeate gas slots in the cap and surface planing of the end caps.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N352638).