The country of origin of transceiver modules
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Ruling text
In your letter dated August 20, 2025, you requested a country of origin ruling, on behalf of your client Accelink Technologies, for Octal Small Form Factor Pluggable transceiver modules. The item concerned is referred to as the 800G OSFP (Octal Small Form Factor Pluggable) DR8 transceiver module. This transceiver module will be mounted to each end of a length of fiber optic cable. The subject merchandise is a hot-pluggable module that plugs into network devices, such as switches in data centers.
It is used to convert an electrical signal into an optical signal, and conversely an optical signal back into an electrical signal. These transceivers are designed for use in 800 Gigabit Ethernet links on up to 500m of single mode fiber. They are used for networking in the data communications sector to receive, convert, and transmit different signals.
The main components of the OSFP transceiver are the Printed Circuit Board Assembly (PCBA) which is manufactured in the United States using Surface Mount Technology (SMT), the Optical Subassembly (OSA) which is manufactured in China, and the transceiver housing. Final assembly, firmware loading, and final testing occur in the United States OSA (China-origin) The OSA includes both a TOSA (transmit optical subassembly) and a ROSA (receive optical subassembly).
The TOSA and ROSA are referred to as “Tx” and “Rx.” The Tx (transmitter) part of the OSA is responsible for converting the electrical signals into optical signals and transmitting these signals over the optical fiber strand in the FA (fiber array) connected to it. One laser diode unit generates and focuses a light beam into a SiPho (Silicon Photonic) integrated circuit.
The photonic integrated circuit splits the light signal into four light beams and takes electrical signals from the main PCBA to modulate the four collected light beams. Then, four lights are launched into the optical fibers of the FA via the isolator focus optics. The light beams then travel to the receptacle connector and out of the optical transceiver. The Tx part of the OSA is manufactured in China and attached to the U.S.-origin PCBA in China.
The Rx (receiver) part of the OSA is responsible for receiving the optical signals transmitted from the Tx part of the transceiver and converting them back to electrical signals so that the communication equipment can understand them. The Rx part of the OSA consists of an Rx block, four photodiodes, two single-layer capacitors, and a transimpedance amplifier. The Rx part of the OSA receives four light beams from optical fibers and sends them to four photodiodes.
It is the photodiodes that convert the light signals into electrical signals which are then amplified by the transimpedance amplifier on the PCBA. The Rx part of OSA is manufactured in China and attached to the U.S.-origin PCBA in China. Main Board PCBA (U.S.-origin) The Main Board PCBA contains the digital signal processor (DSP) chip of U.S.-origin. This part is the highest value part on the BOM and a critical component of the PCBA. The Main Board PCBA is the foundation of the transceiver and imparts its essence.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N352670).