The Country of origin, and eligibility of the United States-Mexico Canada Agreement (USMCA) of LED tube lights from Mexico
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Key passages, quoted from the ruling
- The rate of duty will be 2 percent ad valorem.
Ruling text
This is in response to your letter dated August 22, 2025, your request a United States-Mexico-Canada Agreement (USMCA) eligibility for preferential treatment and country of origin determination for marking purposes and Section 301 applicability for LED tube lights. The merchandise under consideration is identified as the Obert’s LED tube lights, which are 15-Watt linear lamps designed to replace traditional fluorescent tube lights.
The LED tube lights are of two diameters: T8 LED tubes (1 inch diameter) 4 feet long and T5 LED tube (5/8-inch diameter) 4 feet long. The LED tube lights are comprised of LED drivers/PCBs placed in the two end caps of the lamp which electrically connect with the light source/the LED module. The LED module is a circuit board (flexible or hard) placed inside the lamp tube with light sources/LEDs mounted on the circuit board.
There are two working modes for each of Obert’s LED tube lights and the two drivers in the two end caps facilitate the two working modes. Obert’s LED tube lights can function in either a single-ended mode or double-ended mode, which means that any single Obert’s LED tube light can be powered from either one end or two ends depending on the setting of the sockets. When they are powered at one end (single-ended mode), the electrical current does not pass through the second PCB.
The second PCB functions when the LED tube lights are powered at two ends (double-ended mode). This design enlarges the scope of use and increases the adaptability of Obert’s LED tube lights to the sockets.
The applicable subheading for the LED tube lights will be 8539.52.0051, Harmonized Tariff Schedule of the United States (HTSUS), which provides for “Electrical filament or discharge lamps, including sealed beam lamp units and ultraviolet or infrared lamps; arc lamps; light-emitting diode (LED) light sources; parts thereof: Light-emitting diode (LED) light sources: Light-emitting diode (LED) lamps: Straight linear tubes or U-shaped tubes”. The rate of duty will be 2 percent ad valorem.
Effective March 4, 2025, pursuant to U.S. Note 2(u) to Subchapter III, Chapter 99, all products of China and Hong Kong as provided by heading 9903.01.24, HTSUS, other than products classifiable under headings 9903.01.21, 9903.01.22, and 9903.01.23, HTSUS, will be subject to an additional 20 percent ad valorem rate of duty. At the time of entry, you must report the applicable Chapter 99 heading, i.e. 9903.01.24, in addition to subheading 8539.52.0051, HTSUS, listed above.
Effective April 5, 2025, Executive Orders implemented “Reciprocal Tariffs.” All imported merchandise must be reported with either the Chapter 99 provision under which the reciprocal tariff applies or one of the Chapter 99 provisions covering exceptions to the reciprocal tariffs. At this time, products of China, Hong Kong, and Macau will be subject to an additional ad valorem rate of duty of 10 percent.
At the time of entry, you must report the Chapter 99 heading applicable to your product classification, i.e. 9903.01.25, in addition to subheading 8539.52.0051, HTSUS, listed above.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N352763).