The tariff classification of compression limiters from Germany
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Key passages, quoted from the ruling
- The applicable subheading for the compression limiters will be 7326.90.8688, HTSUS, which provides for Other articles of iron or steel: Other: Other: Other: Other: Other.
- The general rate of duty will be 2.9 percent ad valorem.
Ruling text
In your letter dated September 2, 2025, you requested a tariff classification ruling regarding compression limiters from Germany. Product information was submitted with your request. The items under consideration are four models of “wrapped metal” steel compression limiters (Part Numbers CL50-10480, CL50-10463, CL50-10456, CL50-10457).
When plastic vehicle components are fastened to other objects, the normal forces of screws and bolts in a tightened state can exceed the permissible surface pressure of plastic, causing damage. Steel compression limiters are used to prevent such damage by providing structural reinforcement around the cylindrical opening. Based on your submission, the compression limiters will be imported as cylinders of various lengths with an open (split) seam running lengthwise from end to end.
Additional qualities such as diameter, wall thickness, yield strength, edge design, recessing, shaping, and corrosion protection are customizable upon request and may vary. According to your brochure, the compression limiters are available in lengths of up to 80 millimeters and wall thicknesses of .5 to 3 millimeters. In follow-up correspondence, you clarified the compression limiters will be imported separately to be assembled into finished automotive components after importation.
You suggested the compression limiters may be classified under subheading 7318.29.0000, Harmonized Tariff Schedule of the United States (HTSUS), which provides for Screws, bolts, nuts… and similar articles, of iron or steel: Non-threaded articles: Other. We disagree. These compression limiters do not function like the articles of this heading. Instead, they function to prevent the plastic component from cracking under pressure.
Classification under the HTSUS is in accordance with the General Rules of Interpretation (GRIs). GRI 1 provides that the classification of goods will be determined according to the terms of the headings of the tariff schedule and any relative section or chapter notes. In the event that the goods cannot be classified solely on the basis of GRI 1, and if the headings and legal notes do not otherwise require, the remaining GRIs 2 through 6 will then be applied in order.
The Harmonized Commodity Description and Coding System Explanatory Notes (ENs) constitute the official interpretation of the HTSUS. While not legally binding nor dispositive, the ENs provide a commentary on the scope of each heading of the HTSUS and are generally indicative of the proper interpretation of these headings. See T.D. 89-80, 54 Fed. Reg. 35127 (August 23, 1989).
Heading 7326, HTSUS, is a residual or basket provision which covers a wide range of iron or steel articles that are not more specifically provided for elsewhere in the HTSUS.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N353164).